Brodit 539244 Quick Start Manual

Holder with lock

Download this manual

Product 539244

539244 Holder with lock. Passive holder with tilt swivel. 2 keys included.

This holder is to be used when you want to secure your iPad and still have it easy accessable.

The holder is also perfect for use in stores, at exhibitions and any place where you want to use your iPad without

having it easy removable. The holder is made of extra strong plastic and is equipped with a lock. In order to

remove the iPad from the holder you need the key, two keys are included. The holder is mounted onto a tilt

swivel. This mean that you can adjust the angle in order to avoid light reflection on the screen. You can easily

switch between portrait and landscape mode by turning the holder into desired position.

Tablets (Surfpads) should not be installed onto a car's dashboard if they block the view or block key controls.

ProClip (Brodit's vehicle mounting bracket) is designed for installation of smaller devices like mobile phones and

GPS devices, ProClip is not designed for large devices like tablets. In some vehicles the ProClip has an extra firm

fit and can then be used also for installation of a tablet. If you want to place a tablet onto the car's dashboard,

each combination of tablet-car must be examined in detail by you in order to determine if such an installation is

possible in the specific case. Consideration should be given to the position and how firmly the ProClip is in place,

as well as the size of the tablet you wish to use. Brodit will not give any recommendations for such installations.

An installation of a tablet onto a vehicle's dashboard is always done on the customer's own responsibility. Brodit

recommends to use tablets on the car's headrest, installed onto a Brodit headrest mount.

EAN: 7320285392441

Item no 539244 fits:

Apple iPad 2 (For all countries)

Apple iPad New (3rd Gen) (For all countries)

Apple iPad New 4th Gen (For all countries)

Apple iPad New with Retina (Lightning Connector) (For all countries)

1 (2)

Page 1 Consideration should be given to the position and how firmly the ProClip is in place, as well as the size of the tablet you wish to use. Brodit will not give any recommendations for such installations.
Page 2 INSTALLATION INSTRUCTIONS Please read all of the instructions and look at the pictures before attaching the holder. 1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel.