Brodit MultiStand 215780 Quick Start Manual

16 December, 2016, www.brodit.com, © 2016 Brodit AB
Product 215780
215780 MultiStand MultiStand support leg, for larger surfpads. Length: 120 mm. Mounting Adapter and Screws
Included. Black.
This support leg is to be used then you want to convert your current holder into a MultiStand. Easily change the
existing tilt swivel to the support leg instead and you will have a completely new holder!
When using a MultiStand it is easier to carry the surfpad around with you. Convenient to use anywhere at home,
in the car or in the office. Diminishes the risk to drop the device, since the stand is easier to grip than the device
itself. You can use the stand in several angles, just adjust the position depending on area of use. Also adapted
for use in the lap. Made of black ABS plastic.
You can attach the stand onto a wall, or any other place, by using the enclosed mounting adapter. If you want to
be able to attach the stand onto more than one place, you can buy several mounting adapters (see item no
215461).
The support leg is 120 mm long and fits best with larger surfpads.
Tablets should not be installed onto a car's dashboard. The ProClip is designed for installation of smaller devices
(phones), not for large devices (tablets). If you want to place a tablet onto the car's dashboard, each combination
of tablet-car must be examined in detail by you in order to determine if such an installation is possible in the
specific case. Consideration should be given to the position and how firmly the ProClip is in place, as well as the
size of the tablet you wish to use. Brodit will not give any recommendations for such installations. An installation
of a tablet onto a vehicle's dashboard is always done on the customer's own responsibility. Brodit recommends
to use tablets on the car's headrest, installed onto a Brodit headrest mount.
MultiStand film!
EAN: 7320282157807
Item no 215780 fits:
, , (For all countries)
Apple iPad 1 (For all countries)
Apple iPad 2 (For all countries)
1 (3)