Pathos Acoustics AURIUM Operating Instructions Manual

Pathos Acoustics AURIUM Operating Instructions Manual

Headphones class a tube amplifier

Advertisement

1

Advertisement

Table of Contents
loading

Summary of Contents for Pathos Acoustics AURIUM

  • Page 2 The result is the newest Aurium headphone amp. Pure class A, tube pre stage and MOS-FET power stage, zero feedback, the Aurium performs what audiophiles are used to from Pathos: exquisite musicality, transparency, dynamics and total lack of listening fatigue. Flexibility is granted by the possibility to adjust output impedance from 16 to 1,000 Ohm, in order to provide a perfect interface with any kind of headphone.
  • Page 3: Important Safety Instructions

    Important Safety Instructions Any changes or modifications not expressly approved in this anual voids the warranty and your authority to operate this equipment. Always disconnect the unit from the AC outlet before connecting or disconnecting any cables Service should only be performed by authorized Pathos personnel.Users are not allowed to perform any service to this appliance.
  • Page 4 10cm from the top will ensure a sufficient air flow to cool down the unit. Vacuum Tubes Your Aurium is provided with a pair of ECC88 / 6922 tubes. In case you need to replace vacuum tubes, always use same type.
  • Page 5 Dimensions...
  • Page 6 Connections & Controls...
  • Page 7 CAUTION: When connecting your Aurium to other components, make sure all units are off. NOTE: Pathos Acoustics recommends to use only high quality interconnecting cables. Not using appropriate cables prevents your amplifier, your sources, and your loudspeakers from delivering their full potential.
  • Page 8 “OUT TAPE” to the input of a remote audio amplifier: when selecting a source in the Aurium, the signal is then by-passed to the plug TAPE OUT and it is as if it was connected directly to the...
  • Page 9 (3) it is possible to balance the output left / right to adapt to all possible needs. Remote ON/OFF Aurium is provided with one connector for switching on/off via remote (2). Remote ON/OFF OUT: when unit is on, 12VDC are on the connector to turn on other machines provided with compatible remote.
  • Page 10 The balanced XLR output tape has been desired by Pathos to enjoy and fully appreciate the high quality of the Aurium. In fact, by using a balance sources, the sound quality will be excellent and the Aurium and other amplifier connected to this putput, will able to give the best performances.
  • Page 12 Pathos Acoustics srl Via Palù 50/52 36040 Grumolo delle Abbadesse Vicenza ITALIA www.pathosacoustics.com...

Table of Contents