NETGEAR CM1000v2 Quick Start

Connect a Router
After you set up your cable modem and activate your Internet service, you can
disconnect the computer and connect a router to the cable modem.
To connect a router to the cable modem:
1. Reboot the cable modem by unplugging the power cable from the
cable modem and plugging it back in.
2. Wait for the Online LED to stop blinking and light solid green.
3. Use an Ethernet cable to connect the Ethernet port on the cable modem to
the WAN or Internet port on the router.
4. Power on the router.
5. Wait until the router is ready.
6. Connect a computer to the router.
For more information about how to set up your router, see the documentation
that came with your router.
Support
Thank you for purchasing this NETGEAR product. You can visit
https://www.netgear.com/support to register your product, get help, access the
latest downloads and user manuals, and join our community. We recommend that
you use only official NETGEAR support resources.
For regulatory compliance information, visit
https://www.netgear.com/about/regulatory/.
See the regulatory compliance document before connecting the power supply.
Customer-owned cable modems might not be compatible with certain cable
networks. Check with your cable Internet provider to confirm that this NETGEAR
cable modem is allowed on your cable network.
If you are experiencing trouble installing your cable modem, contact NETGEAR at
1-866-874-8924. If you are experiencing trouble connecting your router, contact
the router manufacturer.
Note to CATV system installer: This reminder is provided to call the CATV systems
installer's attention to Section 820-93 of the National Electrical Code which
provide guidelines for proper grounding and in particular, specify that coaxial
cable shield shall be connected to the grounding system of the building, as close
to the point of cable entry as practical.
Quick Start
Ultra-High Speed Cable Modem
Model CM1000v2
Package Contents
Ethernet cable
Cable modem
Power adapter