AIPTEK HyperPen 10000U Quick Start Manual page 9

Step 4: Verifying installation for hardware and driver functions
Use the tips here to verify the tablet function:
1. As soon as the pen tablet itself activates, the LED begins to flash.
2. Tap on any surface with the pen tip to "wake it up" if it has gone into standby
mode. When the pen is not used for some time, a built-in power saving function
makes the pen or mouse enter into standby mode.
3. Press a button on the pen barrel. The LED will light up.
4. Hover or move the pen in the working area, the cursor on the screen should move
accordingly.
4. Hot Cell Tab
a. Hot Edges
Hot edges show the possibilities of allocating hot cells. The
hot cells of HyperPen 10000U are allocated only in the
upper side of the tablet.
b. Hot Pad Layout
You can change the default setting of hot cells by selecting
any of 16 hot cells.
If you want to redefine the hot cells, click 'Define'. Then key
in the program or function, route of where the program is
saved, and parameters if necessary. The string typed will
be passed to the program as parameters. Click 'OK' to
confirm the reset.
If you want to get an overview of all hot cells, click 'Print'.
Notice: There's no Print Key in Mac System.
If you want to clear the initial setting, click 'Clear'
5. Pressure Tab
The pen pressure can be adjusted the indicator between
'Light' and 'Heavy'. Draw on the 'Pressure Test' area to see
the thickness of handwriting under the selected pressure.
8