Digital Watchdog SiteWatch DW-DTWT Quick Start Manual

DW-DTWT |
motion detectors
INSTALLATION AND USER GUIDE
The Walk-Tester is an installation tool that helps to setup DW's motion detectors on-site.
*Each detector has been fitted with and infra-red LED emitter. When activation occurs,
the transmitter sends a signal. This signal is then received by the Walk-Tester and a very
bright LED flashes and an alarm sounds is also activated.
Under normal situations both the LED and the sounder can be seen and heard up to
164ft (50m).
*To verify that your detector is compatible with the Walk-Tester, remove the cover and
look at the bottom of the circuit board for a blue IR LED (see figure 1 below). If the blue
LED is present, the Walk-Tester will be able to communicate with the detector.
1x Walk-Tester
1x mount bracket
1x holder
1x quick setup guide
NOTE: Download all your support materials and tools in one place.
1. Go to: http://www.digital-watchdog.com/resources.
2. Search your product by entering the part number in the 'Search by Product' search bar. Results
for applicable part numbers will populate automatically based on the part number you enter.
3. Click 'Search'. All supported materials, including manuals and quick start guide (QSGs) will
appear in the results.
Attention: This document is intended to serve as a quick reference for initial setup.
It is recommended that the user read the entire instruction manual for complete and proper installation and usage.
Tel: +1 (866) 446-3595 / (813) 888-9555
Technical Support Hours: 9:00AM – 8:00PM EST, Monday thru Friday
Walk-Tester for
Fig.1 Detector's
IR emitter
WHAT'S IN THE BOX

Quick Start Guide

Fig. 2 Walk-Tester holder
and bracket
digital-watchdog.com