Advertisement
CX-ED1079 Series 'Universal' Electric Strike
I NSTA LLAT I O N IN S T RU CT IO N S
4. INSTALLATION
1. Prepare the door jamb as per the appropriate drawing.
2. Install mounting brackets to jamb using 12-24 x 1/2" screws
and pressed metal nuts. Do not tighten.
3. Spacers are used to assure flush final assembly of faceplate
into jamb. Add one or more spacers between jamb and
mounting bracket when face plate extends beyond the jamb.
When the faceplate sits inside the jamb, spacers must be
added between the mounting bracket & the lip bracket.
Mounting Bracket
Spacer
JAMP
VERTICAL CENTERLINE
Note: The products are intended to be installed in accordance with
the installation wiring diagram, mechanical assembly drawings
provided with each product, the local authority having jurisdiction
(AHJ) and the National Electric Code,
NFPA 70. When installed in fail secure mode, the local authority shall
be consulted with regard to the use of possible panic hardware to
allow emergency exit from the secure area.
The electric door strike shall be installed in such a way and in such a
location so as to not impair the operation of an emergency exit device
or panic hardware mounted on the door.
Page 2 of 3
Spacer
Spacer (Option)
Loosen screw to
adjust strike body
12-24 x 1/2"
Flat-Head Screw (2pcs)
12-24 x 1/2"
Make sure the clearance hole in the spacer aligns with the hole
in mounting bracket.
4. Connect wires coming from the low voltage side of the
transformer to wires (black) from strike.
5. Install electric strike jamb by attaching with # 12-24 screws
and lockwashers.
6. Tighten secure 12-24 x 1/2" screws holding mounting
brackets to jamb.
3 3/8"
(86mm)
1 7/32"
L:
(31mm)
DL:
1 3/8"
(35mm)
3 3/8"
(86mm)
1 7/32"
L:
(31mm)
DL:
1 3/8"
(35mm)
3 3/8"
(86mm)
L:
1 7/32"
(31mm)
DL:
1 3/8"
(35mm)
4 7/8"
(124mm)
3 1/2"
(89mm)
4 1/8"
(105mm)
ESP1B + ESP2B
6 7/8"
(173mm)
5 11/16"
(144mm)
6 1/8"
(155mm)
ESP3B
7 7/8"
(200mm)
6 3/8"
(168mm)
7 3/8"
(187mm)
1 3/8"
ESP4B
(35mm)
Advertisement
