Maintenance - Joovy Moon Room Instruction Manual

2 Unpacking from the Travel Bag/Assembling the Playard
• Keep children away from playard while unpacking.
• Open the travel bag and remove the playard and mattress.
• Release each of the Velcro® straps. See Figure 2.1.
• Set the mattress aside and place the playard so it is resting on the feet.
• With the center of the playard up, pull upward on each side rail until it locks into position. You will hear the rails lock into place. See Figure 2.2.
NOTE: There is ONE mechanism that locks BOTH pieces of tubing on EACH side rail. See Figure 2.3.
• Once you have locked the side rails, go back and check each side rail again to be sure they are all locked into position. If they haven't, pull up
again until they are locked. You may need to lift the center of the floor higher.
• Lift up a side of the playard, so that it is standing on one foot and push down the center of the floor. See Figure 2.4.
NOTE: If you wish to use the mattress sheet, please reference the section for attaching the sheet before proceeding.
• Set the mattress inside the playard with the cushion side up. See Figure 2.5.
• Locate the Velcro® straps near the corners of the mattress.
• Slide the straps through the slots in the floor of the playard (See Figure 2.6) and secure them to the underside of the playard. See Figure 2.7.
Pull up on each corner to ensure each corner is secured.
Be careful not to pinch your fingers on the top corners during assembly.
ALWAYS ensure that all side rails are locked into position before using this product.
ALWAYS secure the mattress to the playard floor with the Velcro® straps.
3 Attaching/Removing the Mattress Sheet
Before attaching the mattress to the playard, simply fit the sheet over the mattress with the corners in place. Then, feed the Velcro® straps
through the slots in the sheet so they are exposed. Attach the Velcro® straps as detailed in Figure 2.6.
To remove the mattress sheet, undo the Velcro® straps and feed them through the slots in the sheet. Then, simply pull the sheet off of the
mattress.
Never use playard sheet unless it fits securely on the playard mattress.
4 Folding/Packing the Playard
• Release the Velcro® mattress straps on the underside of the playard. See Figure 4.1.
• Lift the mattress from the playard and set it aside. If necessary, remove the mattress sheet.
• Pull upward on the webbing loop near the center of the playard floor. Be sure that the center is pulled up all the way. See Figure 4.2.
• With the center of the floor pulled up, press the button locate at the center of one of the top rails.
NOTE: The button is sewn inside the fabric near the center of each top rail. See Figure 4.3.
• While pressing the button, lift up slightly and then push down on this rail until the locking mechanism is released on BOTH sides of this top rail.
See Figure 4.4.
NOTE: If the rail tubes do not unlock, do not force them. Lift the center of the floor higher and try again.
• Once BOTH tubes are folded on this top rail, repeat this procedure on the other three top rails until all four top rails have been folded.
• Gather the playard together until it is compact and completely folded. See Figure 4.5.
NOTE: DO NOT force the playard. If the unit will not fold, look for a partially latched top rail and push the button in to release the rail.
• Lay the mattress on the floor with the cushion side facing up. Lay the folded playard frame on the mattress and fold the mattress around it. See
Figure 4.6.
• Locate the Velcro® straps on the end of the mattress, thread them through the plastic rings on the other side of the mattress and attach them.
NOTE: There are three straps; one near the top, one near the center and one near the bottom.
• Stand the playard upright.
• Open the travel bag and slide the playard in. Once the playard is completely inside the travel bag, close the zipper. See Figure 4.7.

Maintenance

Inspect all of the parts of the playard periodically to ensure that they are secured, not torn or damaged and functioning properly. Any missing,
broken, or worn components should be replaced immediately, and the playard should not be used until they are replaced. Only original
manufacturer's components should be used. If needed, please contact Joovy.
Adult assembly is required for this product. No tools required.
NEVER use items not recommended by Joovy with this product.
Prevent possible strangulation or entanglement.
WARNING
!
WARNING
!
WARNING
!
EN
FR ES