Electrical Connection - T.I.P. SPF 180 Operating Instructions Manual

the isolation valve no water runs out of the pool.
1 inlet from the pump (marked "pump")
2 outlet to the swimming pool (marked "pool") for normal filter operation
3 outlet for waste water (marked „waste") for back wash
4 pressure gauge
Please make sure there is always sufficient water supply from the suction point in the filter tank before you prime the
pump. If you are unable to prime the pump please see the trouble-shooting guide.
1. Remove the translucent lid and fill the filter tank with water.
2. Replace the lid ensuring the o-ring is correctly located and start the pump.
After you have done this allow a few minutes (maximum) running for the pump to start delivering water.
High suction lift or long suction hoses require additional time and reduce the performance of the pump.
If the pump does not prime, repeat steps 1 and 2 (see above).
Make sure, there is sufficient in the sand filter tank before priming the pump
If the pump does not prime, please observe the notes in the section trouble shooting.
Make sure, all inlet and outlet valves are open, before priming the pump. Otherwise this could cause severe damage of
the pump.
5.4. Fixed installation
For fixed installation of the electrical connection, make sure the plug can be easily reached and is
visible.
For fixed installation the pump should be placed on a solid, horizontal surface.
6.

Electrical connection

The unit is equipped with a mains connection cable and a mains plug. It must only be replaced by qualified staff to avoid
any danger. Please do not use the mains connection cable to carry the pump, and do not use this cable to pull off the plug
from the socket, either. Protect the mains connection cable and mains plug from heat, oil or sharp edges. Defect power
18
fig. 7
6