Names Of Each Control - Teac Esoteric G-0s Owner's Manual

A
STANDBY/ON button
When the Main Power switch on the rear panel is ON, use
this button to turn the unit on or to standby. When the unit
is on, the indicator lights.
B MASTER button
Press this button to select the signal source you will use for
the reference frequency.
When the clock signal is stabilized, the indicator for the
MASTER button stops blinking and lights steadily.
Xtal:
When using the clock made by internal crystal oscillator
Rb:
When using the internal rubidium oscillator as the source
clock
Ext:
When using the input from the reference sourced 10MHz IN
terminal
C
UNIVERSAL CLOCK OUT button
Use this to switch the Universal Clock output on or off.
Universal Clock is the TEAC-ESOTERIC original clock for
universal players.
When the FREQUENCY MODE is set to 44.1kHz or 48kHz,
the frequency of the universal clock is set to 100kHz. When
the FREQUENCY MODE is set to PAL FILM, the frequency of
the universal clock is set to 96kHz.
When OFF is selected, the indicator turns off.

Names of Each Control

A B C D E
D
FREQUENCY MODE button
Use this to select the fundamental frequency of the word
clock.
44.1kHz:
This is generally used for red-book CD players which operate
with a 44.1kHz clock standard.
48kHz:
This is used for DVD players, DAT recorders, etc. which
operate with a 48kHz clock standard.
PAL FILM:
This is used for reproducing PAL DVD discs at 24 frames/sec.
E
Frequency change buttons [A/B/C]
The frequency of the each line (A/B/C) is changeable
between 1x/2x/4x of the fundamental frequency and off.
Following frequency can be selected for each FREQUENCY
MODE.
When OFF is selected, the indicator turns off.
44.1kHz:
44.1kHz, 88.2kHz, 176.4kHz
48kHz:
48kHz, 96kHz, 192kHz
PAL FILM:
48P (46.08kHz), 96P (92.16kHz), 192P (184.32kHz)
5