Carpet Cleaning - Bissell BG10 10N2 Series User Manual

Operations
Before you clean:
1. Move furniture to another area if cleaning the entire room
(optional.)
2. Vacuum area with a dry vacuum cleaner thoroughly before
deep cleaning.
3. Plan your cleaning route to leave an exit path. It is best to
begin cleaning in the corner farthest from your exit.

Carpet cleaning:

1. Remove dirty water tank. Pull dirty water tank handle to
upright position and lift up to remove dirty water tank.
2. Lift clean water tank from the base of machine.
A. Unscrew cap on top of the clean water tank. Fill tank to
FILL line with clean, hot tap water.
B. Measure BISSELL formula using cap on tank. Fill cap to
line twice for each full tank of water. Always use genuine
BISSELL formulas to maximize cleaning and for the safety
of your machine
C. Screw cap back onto clean water tank and place tank
onto base of the machine.
Replace dirty water tank securely on top of the clean water
3.
tank and push handle back to lock into place.
4. Plug into a proper outlet and turn the power switch to the
ON ( I ) position.
5. Detent handle by pushing down on the green lever on the
back of the machine while pulling back.
Cleaning strokes. While pressing the trigger, make one
6.
slow forward wet pass and another back. Let the formula
and DirtLifter PowerBrushes do the work for you.
Note: Your machine is equipped with a circuit breaker
that will automatically shut off the brush if a large or
loose object is caught in the brush roll. If that happens,
be sure to unplug your machine, remove the foreign
object and then plug machine in to reset the circuit
breaker.
4 w w w. a s t o n i z e . c o m
ATTENTION:
Some Berber carpets have a tendency to fuzz with wear.
Repeated strokes in the same area with an ordinary vacuum
or deep cleaner may aggravate this condition.
1.
2.
2C.
3.
5.
7 8 0 . 7 0 1 . 5 1 1 2
1.
2A.
3.