Tools Required; Hardware Included; To Lock Chest; To Unlock Chest - Craftsman 33507 Operator's Manual

Tools Required:
3/8 inch wrench
5/16=inch drill bit
HARDWARE INCLUDED:
1/4 - 20 x 5/8" (Qty: 4)
1/4 - 20 Nut (Qty: 4)
iiiiii_,, ..... " iii_
Chest:
Hardware bag
Literature
NOTE: Not all operation instructions wilt relate to your
model.
TO LOCK CHEST
Process:
o Make sure drawers are fully closed.
o Insert the tockbar (which stores in the top tray), tabbed
end up, into the slot in the top tray and down into the slot
in the base.
o Close the cover and lock with the key.
TO UNLOCK CHEST
o Reverse above procedure..
REMOVING DRAWERS
o Empty the drawer.
o Fully extend the drawer.
Release
TO ATTACH CHEST
Process:
. Remove enough drawers to access the top and bottom
mounting surfaces of the units. See Operation Section,
Part B.
. Place the chest in the desired location on top of the cabi-
net or intermediate chest and mark the mounting hole
locations onto the cabinet top.
. Remove the chest and drill two 5116" (8mm) holes
through the top of the cabinet or intermediate chest.
. Secure the units together using two 1/4 - 20 x 5t8"
screws and nuts at each joint. The hardware is provided
in the bag located in the top tray of the chest.
. Reinstall drawers. See Operation Section, Part C.
Lever Styme - Lift or lower (depending on the slide) the
release lever on both sides, (this allows the slides to ride
over the stops.) Putt out to remove.
\\\\\\\\\\\\\\\ \\