Page 24
Το μοντέλο 865 ALG είναι εξοπλισμένο με δίσκο (ταψί) βάθους 80 mm. Για αποδοτική χρήση τοποθετείτε το δίσκο στην 3η θέση. Ο δίσκος 80 mm δεν θα πρέπει να χρησιμοποιείται στην 1η (τη χαμηλότερη) θέση. Δεν συνιστάται μαγείρεμα με δύο δίσκους των 80 mm ταυτόχρονα.
Page 37
UFG-60300 OPERATING AND INSTALLATION INSTRUCTIONS OF DUAL FUEL FREESTANDING OVEN EG631M...
Page 38
Dear Customer, Our goal is to offer you products with high quality that exceed your expectations. Your appliance is produced in modern facilities carefully and particularly tested for quality. This manual is prepared in order to help you use your appliance that is manufactured by the most recent technology, with confidence and maximum effciency.
Page 39
CONTENTS: 1.PRESENTATION SIZES OF PRODUCT 2. WARNINGS 3. INSTALLATION AND PREPARATIONS FOR USE 4. INSTALLATION OF OVEN 5. CLEANING AND MAINTENANCE 6. SERVICE AND TRANSPORT...
Page 40
2- Cooktop 11- Oven Lamp 3- Control Panel Rapid Burner 4- Oven Door Handle Auxillary Burner 5- Drawer Cover Hobe Grids SIZE(cm) MODEL 6- Supply leg mi-Rapid Burner 7- Oven Door Hotplate UFG-60300 EG631M 60*60*85 8- Oven Tray 9-Wire Grid...
Page 41
PART 2 SAFETY WARNINGS READ THESE INSTRUCTIONS CAREFULLY AND COMPLETELY BEFORE USING YOUR APPLIANCE, AND KEEP IT IN A CONVENIENT PLACE FOR REFERENCE WHEN NECESSARY. THIS MANUAL IS PREPARED FOR MORE THAN ONE MODEL IN COMMON. YOUR APPLIANCE MAY NOT HAVE SOME OF THE FEATURES THAT ARE EXPLAINED IN THIS MANUAL. PAY ATTENTION TO THE EXPRESSIONS THAT HAVE FIGURES, WHILE YOU ARE READING THE OPERATING MANUAL.
Page 42
- WARNING: If the surface is cracked, switch off the appliance to avoid the possibility of electric shock. - For hobs incorporating a lid, any spillage should be removed from the lid before opening. And also the hob surface should be allowed to cool before closing the lid.
Page 43
- WARNING: Ensure that the appliance is switched off before replacing the lamp to avoid the possibility of electric shock. - CAUTION: Accessible parts may be hot when the cooking or grilling is in use. Young children should be kept away. •...
Page 44
During usage • When you first run your oven a certain smell will emanate from the insulation materials and the heater elements. For this reason, before using your oven, run it empty at maximum temperature for 45 minutes. At the same time you need to properly ventilate the environment in which the product is installed.
Page 45
Part 3: INSTALLATION AND PREPARATION FOR USE This modern, functional and practical oven, that was manufactured with the parts and materials of highest quality, will meet your cooking needs in every aspect. You must surely read this manual so that you don't have any problem in future and to be able to have satisfactory results.
Page 46
These air holes must have at least the effective cross section of 100cm3 for fresh air circulation (One or more air holes can be opened.). This hole (or holes) must be opened so that they are not blocked. Preferably they must be placed close to the bottom and at opposite side of the smokes of the burned gases that were emptied.
Page 47
ADJUSTMENT OF FEET Your oven stands on 4 adjustable feet. When the oven is placed where it will be used, check if the oven is balanced. If it is not balanced, you can make the adjustment by turning the feet clockwise if required. It is possible to raise the appliance maximum 5mm by the feet.
Page 48
ELECTRICAL CONNECTION AND SAFETY All types free standing ovens in which termýnals for permanent connectýon by means of terminal block. This appliance must be installed by a qualified person in accordance with the latest edition of the national regulations in the destination country and in compliance with the manufacturer instructions The appliance does not incorporate any means for disconnection from power supply.
Page 49
IMPORTANT: The wires in mains lead are coloured in accordance with the following code: GREEN and YELLOW …………. EARTH BLUE ……………………………..NEUTRAL BROWN or RED………………….LIVE 50x60 full gas oven with gas hob, with gas hob and one hotplate and 60x60 electric oven with gas hob types free standing ovens with supply cord and plug This appliance must be installed by a qualified person in accordance with the latest edition of theIEE regulations and in compliance with the manufacturer instructions...
Page 50
GENERAL WARNINGS AND MEASURES Your appliance is produced in accordance with the local and international standards and regulations applicable. The maintenance and repair works must be made only by authorized service technicians. The installation and repair works without following proper knowledge may endanger you. While your appliance operates, its outside surfaces heat up.
Page 51
Figure 7 Figure 6 Figure 9 Figure 8 Adjusting The Reduced Flame Position : The flame length in the minimum position is adjusted with a flat screw located on the valve. For valves with FFD, the screw is located on the side of the valve spindle. For valves without FFD, the screw is located inside the valve spindle.
Page 52
USE OF GAS BURNERS Ignition of the burners: To determine which knob controls which burner, check the position symbol above the knob.: Manual Ignition: If your appliance is not equipped with any ignition aid or in case there is a failure in the electricity network, follow the procedures listed below: To ignite one of the burner, press and turn its knob counter-clockwise so that the knob is in max.
Page 53
Rapid Burner: 22-26cm Medium Burner: 14-22cm Auxiliary Burner: 12-18cm Make sure that the tips of the flames do not spread out of the outer circumference of the pan, as this may also harm the plastic accessories around the pan (handles etc.) When the burners are not in use for prolonged periods, always turn the main gas control valve off.
Page 54
WARNING When the operating for the first time or whenever the hotplate has not been used for prolonged of time it is necessary to eliminate any humidity which may have accumulated around the electrical elements of the plate by operating the hotplate on its lowest setting for about 20 minutes. Use only flat pans and with a sufficiently thick base.
Page 55
USE OF OVEN PART Oven Function Selector Switch: Enables you to select the function of the oven. Each position of the selector knob activates the function that is shown on the symbol of that position. The explanation of each symbol is given in the table below. For functions other than oven light and defrost, the function you have selected will not be activated unless you adjust the temperature with thermostat knob, to a position other than “0”.
Page 56
Oven Functions: Oven functions, which can be selected by the oven function switch, are summarized in the following table: Your oven's lamp starts to operating. Your oven's lamp, red warning lamp and fan start to operating. It performs the function of defrosting your frozen food. Your oven's thermostat and warning lamps and lower and upper heaters start operating.
Page 57
Ice Metter Function: You can start the defrosting process by placing the frozen food into your oven and turning the switch onto the determined sign. This is a program that does not cook the food, just helps to defrost them in a short time.
Page 58
Grill + Rotisserie Function: This function is used for grilling. In order to grill, please use the grill pan supplied with your product. Turn your top oven's switch as it will show the sign of this function. For details, please refer to the cooking table.
Page 59
Energy Saving During use of electrical cookers, it is required to use saucepans having flat bases. Choose a cookware of proper size. Using a cookware lid will reduce cooking times. Minimize the amount of liquid or fat to reduce cooking times. When liquid starts boiling, reduce the heat setting.
Page 60
Digital Timer Time of Day Adjustment: Before starting to use your oven, you need to adjust your timer. When the electric power is connected to your oven, the symbol “A” and three “0” s will begin to flash on the screen. In this state, your oven will not operate. Press the Press the (+ ) and (-) keys simultaneously.
Page 61
Semi-Automatic Programming According to End Time : This function is used to cook according to the desired end time of cooking. The food to be cooked is put into the oven. The oven is adjusted to the desired cooking function. The oven thermostat is adjusted to the desired degree depending on the dish to be cooked.
Page 62
Digital Minute Minder Simultaneously press (+) and (-) buttons of digital timer. The display will start flashing, and then you can set the time setting by using (+) and (-) buttons. When you pres (+) or (-) button after setting the time, symbol is displayed, and the desired time duration is set.
Page 63
Accessories Used in Oven The oven already supplied with accessories. You can also use accessories you purchase from the market, but they must be heat and flame resistant. You can also use glass dishes, cake molds, special oven trays that are appropriate for use in oven. Pay attention to the using instructions by the manufacturer of those acessories.
Page 64
Part 5 : CLEANING AND MAINTENANCE OF YOUR OVEN CLEANING Be sure that all control switches are off and your appliance cooled before cleaning your oven. Plug off the appliance. Check whether they are appropriate and recommended by the manufacturer before using the cleaning materials on your oven.
Page 65
MAINTENANCE Change of Oven Lamp At first plug the oven off from electric supply and make sure that oven is cool. Remove the bulb after removing the cover in front of lamp. Assemble the new bulb resistant to 300 C to the place of the bulb that you removed (230 V, 25 Watt, Type E14).
Page 66
Part 6 : SERVICE AND TRANSPORT Requirements Before Contacting to Service If the oven does not operate; The oven may be plugged off, there has been a blow-out. On models fitted with a timer, time may not be regulated. If the oven does not heat; The heat may be not adjusted with oven's heater control switch.
Need help?
Do you have a question about the UFG-60300 and is the answer not in the manual?
Questions and answers