Table of Contents
Advertisement
Available languages
Available languages
FORWARD/REVERSE SWITCH
The
cordless
equipped with a convenient switch
that functions as both an ON/OFF
switch and FORWARD/REVERSE
switch.
1.
To drive screws, press the
right hand side of the switch (1) (Fig.
3). To turn the switch OFF, release
the switch.
2.
To remove screws, press the
left hand side of the switch (2).
PIVOTING HANDLE
The
handle
screwdriver is designed to pivot to
various angles. This feature allows
you to configure the tool for easier
access in hard to reach locations. It
also makes it easier to apply extra
torque in manual mode.
Fig.2
screwdriver
Fig.3
of
the
cordless
To pivot the handle, simply "bend" the
tool in the middle to the appropriate
angle (1) (Fig. 4)
is
PREPARING SCREW HOLES
It is important to prepare screw
holes before attempting to fasten
two pieces of wood together. Proper
preparation will make screws drive
easier
and
components, stripped screw heads,
splitting and separating of wood
components.
1.
Clamp
are to be screwed together in their
desired position (Fig. 5).
2.
Drill a pilot hole (1) through
the outer piece (2) and into the inner
piece (3). Drill hole 2/3 the diameter
of the smooth portion of the screw
shank.
NOTE: If the wood is soft, drill the
hole 2/3 the length of the screw. If
the wood is hard, drill the hole the
full length of the screw.
3.
Remove the clamp from the
two pieces to be screwed together.
4.
Enlarge the hole (1) in the
outer piece (2) so that it is the same
prevent
misaligned
components
Fig.4
that
10
Advertisement
Table of Contents
