Craftsman 33508 Operator's Manual page 2

Tools Required:
3/8 inch wrench
5/16-inch drill bit
HARDWARE INCLUDED:
1/4 - 20 x 5/8-in (Qty: 4)
NOTE: Not all operation instructions will relate to your model.
TO LOCK iNTERMEDiATE CHEST
The Iockbar for the intermediate chest is stored in the
top drawer.
Process:
- Insert the Iockbar into the slot in the base.
- Move the Iockbar toward the unit until the bent end fits
into the slot near the lock.
- Lock with the key.
1/4- 20 Nut (Qty: 4)
Intermediate Chest:
Literature
Hardware bag
TO UNLOCK INTERMEDIATE CHEST
- Reverse above procedure.
REMOVING DRAWERS
• Empty the drawer.
• Fully extend the drawer.
Release
TO ATTACH CHEST
Process:
• Remove enough drawers to access the top and bottom
mounting surfaces of the units. See Operation Section,
Part B.
• Place the chest in the desired location on top of the
cabinet or intermediate chest and mark the mounting
hole locations onto the cabinet top.
• Remove the chest and drill two 5/16" (8mm) holes
through the top of the cabinet or intermediate chest.
• Secure the units together using two 1/4 - 20 x 5/8"
screws and nuts at each joint. The hardware is provided
in the bag located in the top tray of the chest.
• Reinstall drawers. See Operation Section, Part C.
Lever Style - Lift or lower (depending on the slide) the
release lever on both sides, (this allows the slides to ride
over the stops.) Pull out to remove.