Advertisement
3 Description of the product
3.1 Technical data - unit
weight
height
width
depth
system of protection
3.2 Function
The magnetic field of the „Power Clean" causes the steel pins to rotate.
This rotation effect and the Quick Clean cleaning solutions combine to clean and condense the surfaces of anti-
magnetic material.
4 Installation and Setting-Up/Operation
4.1 Installation, location, connecting
The „Power Clean" is supplied ready for use.
Procedure:
Unpack the unit and check that it is complete
•
Decide where to install it:
Easy access and easy to look in the vessel
•
Space for accessories
•
230 V~ 50/60 Hz power supply.
•
Place the unit on a level, nonskid surface.
•
Then place the denture in the cleaning vessel and fill it with 130ccm of water.
•
Add our recommended cleaning solutions in.
•
The vessel must be closed while „Power Clean" is running.
•
The clear-transparent lid is the gasket.
Place the cleaning vessel on the platform.
•
Now you can switch on the timer with the sensor-switch and set the desired cleaning time
Ensure that the vessel is closed.
To avoid that the vessel is spinning on the platform, you can put a piece of paper between the vessel and
•
the platform.
This avoids also impurity of the unit.
.
Once the denture has been cleaned, remove it and rinse it thoroughly with water.
•
2,9 kg
145 mm
145 mm
230 mm
IP 00
micro fuse
T 200mA/ 250 V
power supply
230 V/ 50 Hz
wattage
30 W
speed
1200 – 1800 U/min.
plug
DIN plug
Advertisement
