Quoizel PO9140 Series Installation Manual

Please go to www.quoizel.com
Tools Required: Flathead screwdriver, Phillips screwdriver, Shovel, Electrical tape, Wire cutter, Safety glasses, Wire strippers and proper length
wires (not included).
Estimated Assembly Time: 30-45 minutes
Preparation: Identify and inspect all parts before beginning installation. Check package content list and diagrams below to be sure all parts are
present. If any parts are missing or damaged, do not attempt to assemble, install, or operate the fixture. Contact customer service for replacement
parts.
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Package Contents
Big Allen Wrench
A
x 1
Small Allen Wrench
B
x 1
Anchor Bracket
C
x 1
Allen Bolt
D
x 3
Lock Ball
E
x 3
Washer
F
x 3
Spring Washer
G
x 3
Hex Nut
H
x 3
Anchor Bolt
I
x 3
Allen Set Screw
J
x 4
2018 QuoizelInc.
for product cleaning tips. Go to the
Post Fitter
K
x 1
Upper Post
L
x 1
Middle Post
M
x 1
Bottom Post
N
x 1
visit us on-line at www.quoizel.com
Installation Guide #IS-PO9140
For Style PO9140XX
Care + Maintenance selection.
-
STEP 1 Assemble Anchor Bolts to the Anchor Bracket
A. Remove all Spring Washers (G), Hex Nuts (H) and Lock Balls (E)
from the Anchor Bolts (I).
B. Screw the threaded end of each Anchor Bolt (I) in the Mounting
Bracket (C) making sure to that the Anchor Bolt (I) is 1.75" to 2"
extended from the bottom of the Bracket (C).
C. Place a Spring Washer (G) over the Anchor Bolt (I) and then thread
the Hex Nut (H) onto each Anchor bolt (I). Securing the Bracket (C) in
place maintaining the 1.75"-2" length of the Anchor Bolt (I).
-
STEP 2 Install Anchor
Bolts in the ground
A. At the desired location for
the post a hole with a
minimum depth of 15" is
required for proper
installation of the post
mount. Please check with
local building codes as
local codes will always
supersede these
instructions.
B. Use cement to secure the
Anchor Bolts (I) into the
ground making sure that
the Bracket (C) is flush on
top of the cement and level
Anchor at the desired
grade with the ground. This
is the base for the Post
Mount.
1of3
H
H
G
C
1.75" - 2"
C
I
I
Figure 1
C
Wires
1.75" - 2"
Earth
Tube
Bolt Circle
Figure 2
ReleasedDate:2018-10-09
G
I
Cement
Earth
Dia. 9"
Bolt