Advertisement
10. Open water supply and turn on both Boiling & Chilled Water levers at
the Fusion boil/chill tap until water flows without air bubbles.
11. Plug both units into power points and switch on, allow 20 minutes
prior to testing and use.
12. Check for leaks at all connections and tighten if necessary.
13. Position 'Caution Boiling Water' label close to the tap to alert users to
take care when using the hot tap.
Trouble Shooting
SYMPTOM
Water Overflowing
from tap Spout
Excessive Steam
from tap
Water not hot
Water not cold
No water
For more information about Ecoboil and our products,
Water boilers
|
Water chillers
CAUSES
Expansion chamber full
Low Inlet Pressure
Faulty Element
No power supply
Faulty element
No power supply
Water has been turned off
Blocked filter
visit our website or contact us:
Ecoboil Appliances Limited
Phone 09 238 2209
Fax 09 282 4073
Mail P.O. Box 940, Pukekohe 2340
Web www.ecoboil.co.nz
|
Boil/Hot units
ACTION
Run Tap for 5-10 minutes
Contact water supplier
Replace element
Check and test power supply
Replace element
Check and test power supply
Check Mains water supply
Clean or replace filter cartridge
|
Boil/Hot/Chill units
|
Parts & Accessories
Advertisement
