Advertisement
Soldering & Rework Station
QFP Soldering:
1.
Apply the solder paste. Apply the proper quantity of solder paste and install the SMD on the PCB
2.
Preheat SMD. Refer to the photo to preheat SMD
3.
Soldering heat the lead frame evenly
4.
Washing when soldering is completed, wash away the flux
Note : While here is a merit to solder by Hot air, it's also possible to cause the defects such as solder balls, older bridges.
We recommend you to examine the conditions of soldering sufficiently.
Precautions:
1.
Before attach the nozzle, make sure that both the heating tube and the nozzle are cool down
2.
Caution high temperature operation do not use the unit near ignitable gases, paper, or other inflammable materials.
Both the nozzle and the heated air are extremely hot and can cause painful burns. Never touch the heater pipe or allow
the heated air to blow against your skin. Initially, the iron may emit white smoke, but this will soon disappear
3.
After use, be sure to cool the unit. After turning off the power switch, the unit will automatically blow cool air through
the pipe for a short period of time. Do not disconnect the plug during this cooling process
4.
Never drop or sharply joint the unit. The pipe contains quartz glass, which can break if the unit is dropped or jolted
sharply
5.
Disconnect the plug when you don't use the unit for a long time. When the power cord is connected into the power
supply, the unit has a little flow of electricity, even the power switch is in off position. So when you don't use the unit for
a long time, disconnect the plug
Replacing the Heating Element:
1.
Remove the screws, slide the tube. Remove the 3 screws, which secure the Handle and slide the cord tube
2.
Open the handle. Disconnect the ground wire sleeve and remove the pipe. In the pipe. The quartz glass and heat
insulation is installed. Do not drop or miss it
3.
Remove the heating element. Disconnect the terminal and remove the heating element
4.
Insert a new heating element. Handle it with care. Never rub the heating element wire. Insert a new heating element
and reconnect the terminal. Reconnect the ground wire after replacing the element. Assemble the Handle in the
reverse order of disassembly. Insert the Handle's projection into the hole in the pipe
מיקום באתר: מלחמים וציוד הלחמה / מלחמים ותחנות הלחמה / תחנות הלחמה
דיגיטלית
אוויר חם
תחנת
560W
2362602
יבואן: טלמיר אלקטרוניקה בע"מ
TM
:תיאור פריט
:יצרן
TENMA
:דגם
21-10125
:מק"ט טלמיר
Advertisement
