Advertisement
Concept
FEATURES CR120/150
1 2 3
GAIN
BASS TREBLE
MIC
LINE
FX
REV
7
8
9
10
WARNING THIS EQUIPMENT MUST BE EARTHED
SUPPLY VOLTAGE - 115V -T2A
& FUSE RATING
- 230V - T5A
POWER
1
0
MAXIMUM POWER CONSUMPTION
240 WATTS -50-60 Hz
MADE IN THE UNITED KINGDOM BY BLT INDUSTRIES
15
1
GAIN:
Adjusts channel level, this enables the user to balance gain levels across each channel.
2
BASS:
Adjusts the channels low frequency response.
3
TREBLE:
4
PRESENCE:
5
REVERB:
6
MASTER:
7
MIC:
XLR input for low impedance microphone (200-600 Ohm)
8
LINE:
Jack input socket for all line level signals eg: Keyboard, mic or drum machine.
9
FX:
Switches the FX units to channels ON and OFF.
10
REV:
Switches the reverb to channel ON and OFF.
11
TAPE/CD IN:
12
TAPE OUT:
13
SEND & RETURN:
14
FOOTSWITCH:
15
POWER:
16
SPEAKER OUTPUTS:
CR120 will deliver 120 watts into 4 Ohms the CR150 will deliver 150 watts into 4 Ohms. Under no
circumstances should the total load seen by the amplifier be below 4 Ohms. Thermal shutdown is
likely to occur and may result in long term reliability being impaired.
17
LINE OUT:
GAIN
BASS TREBLE
GAIN
MIC
MIC
LINE
FX
REV
CAUTION TO REDUCE THE
RISK OF FIRE HAZARD
REPLACE FUSE WITH SAME
TYPE AND RATING ONLY
CAUTION TO REDUCE THE
RISK OF ELECTRIC SHOCK
DO NOT REMOVE COVERS.
NO SERVICABLE PARTS
INSIDE. REFER SERVICING
TO QUALIFIED SERVICE
Adjusts the channel high frequency response.
Controls the high frequency responce of the power amplifier.
Controls the overall reverb output level.
Master volume control, controls the overall volume
Phono input for tape or CD playback.
Phono output sockets for tape recording.
Send & return sockets for connecting effects units to the effects loop.
Socket for connecting optional footswitch for reverb switching.
Power On/Off switch.
Two jack sockets are provided for connection of loudspeakers. The
Jack socket supplying a signal that can be used to drive additional power amps.
BASS TREBLE
GAIN
BASS TREBLE
MIC
TAPE IN
LINE
FX
REV
11
ATTENTION REMPLACER LE
FUSIBLE PAR LE MEME ET LE
CALIBRE
TOTAL MINIMUM LOAD
= 4 OHMS
SPEAKER OUTPUTS
16
4 5 6
PRESENCE REVERB MASTER
Laney
TAPE OUT
FX
REV
FX
RETURN
FOOTSWITCH
SEND
12
13
14
SERIAL No;
LINE OUT
17
CR Manual
Advertisement
