Special Con Gurations; Pairing To A Bt Remote - Midland BTCity Manual

Attention: never set the volume of the MP3 Player to the maxi-
mum possible.
Hint: We recommend that you perform a few tests adjusting the volume of
your iPod/MP3 player so at the normal speed the Headset volume is suited
to your needs. The AGC system will automatically increase the volume on
higher speed. Make a note to remember this setting for future trips.
Attention: the volume adjustment, ("Volume+" and "Volume –")
buttons, cannot be used to adjust the volume of the wired audio
source(eg MP3 player).
Enabling/disabling the wire input
The wire input can be enabled and disabled
› Enabling: double click the "Control" button (you will hear one audio
confirmation tone).
› Disabling: double click the "Control" button(you will hear two audio
confirmation tones).
Using a Two Way Radio transceiver
To be able to use the transceiver, it is necessary to purchase a specific
cable (sold separately) in order to connect the radio to your Midland
BTCity:
Some manufacturers radios use a different pin configuration, so we
recommend that you ask your dealer as to which cable is best suited
to your needs.
To communicate via the attached radio, press the transmission Press To
Talk (PTT) button to speak and release it to listen. It is not possible to
talk and listen simultaneously. Communications can be activated also
without pushing the PTT button, by enabling the VOX function.

Special con gurations

Some Midland BTCity features can be configured to suit specific needs:
› Pairing to BT Remote
› Adjusting/ Disabling the VOX feature (Intercom and telephone)
› Wired connection always on
› Intercom and GPS
10
Pairing to a BT Remote Unit
When paired to a BTRemote unit, you will have available all the 5
buttons of the remote unit:
When you are in "Intercom" mode
› Press short the "Control" button to open /close the intercom
When you are in "Phone" mode
› Press short "Forward" button: voice dial/answer incoming call
› Press long "Forward" button: dial last number/reject incoming call
› Press short "Control" button: Play/Pause music
When the music is playing:
› Press short "Forward" button: forward a song
› Press short "Backward" button: backward a song
› Press short "Control" button: Play/Pause music
In all mode (Intercom or Phone)
› Press long "Backward" button: enable/disable wired AUX input
› Press very long "Backward" button (7 sec.): enable/disable Vox
Adjusting/ Disabling the VOX feature
(Intercom and telephone)
The Intercom feature can be enabled both manually and vocally
(VOX). The VOX activation is influenced by the background noise and
therefore by the speed.
For optimum results, it is possible to choose one of the following four
microphone sensitivity levels: high, medium, low and very low. The
default setting of BTCity is "high". It is also possible to disable the VOX
feature in order to activate the Intercom and phone call answering
features in manual mode only.
Adjusting the sensitivity of the microphone (VOX)
1. Enter the Setup mode: Switch your BTCity off.
Press and hold down the central button (Control) until the red
indicator switches on permanently. Your BTCity is now in "Set up
mode".
2. Press the "Volume+" and "Control" buttons till the red indicator