Advertisement
Quick Links
®
TO GET THE MOST OUT OF
YOUR ZERO GRAVITY MICRO™
WALL RACER PLEASE READ THESE
INSTRUCTIONS FIRST!
NOTE:
USE ON SMOOTH, CLEAN
SURFACES ONLY!
Check to make sure contents are
complete:
• 1 Zero Gravity Micro™ Wall Racer
• 1 Controller/Charger
• 1 Instruction Sheet
INSTALL BATTERIES
Battery
CLOSE
OPEN
Compartment
Door
Six
1.5-V AA
Alkaline
Batteries or
Rechargeable
Batteries
Battery
Compartment
Controller/Charger
6. Green light
flashing: Vehicle
is charging.
Green light off:
Vehicle is charged.
• Charging should take bet ween 30 and 50 minutes depending on how much charge is left in car.
• NOTE: Do not charge battery immediately after use. Let car battery cool for at least 10 minutes. If charging is not complete in 50 minutes,
replace the charger batteries.
PROBLEMS? Before you return to retailer, please call our HOTLINE for assistance,
All manuals and user guides at all-guides.com
INSTRUCTIONS
1. Switch
car to
"OFF".
4. Plug cable
into port
of vehicle.
Make sure
the arrow is
on top.
7. When charged,
turn controller/
charger switch
"OFF".
™
Your Zero Gravity Micro
battery inside the vehicle body.
1-800-622-8339
ADULT SUPERVISION RECOMMENDED!
TM
Zero Gravity Micro™
Wall Racer
CHARGING YOUR ZERO GRAVITY MICRO™ WALL RACER
2. Switch
controller/
charger to
"OFF".
Wall Racer has a pre-installed rechargeable
FOR INDOOR USE ONLY.
Controller/Charger
3. Take
out
charge
nozzle.
5. Slide
switch on
controller/
charger to
"CHARGE".
8. Stow
charge cable
in storage
compartment.
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Air Hogs Zero Gravity Micro
Summary of Contents for Air Hogs Zero Gravity Micro
- Page 1 USE ON SMOOTH, CLEAN SURFACES ONLY! Controller/Charger Check to make sure contents are complete: Zero Gravity Micro™ • 1 Zero Gravity Micro™ Wall Racer Wall Racer • 1 Controller/Charger • 1 Instruction Sheet INSTALL BATTERIES CHARGING YOUR ZERO GRAVITY MICRO™ WALL RACER 1.
- Page 2 All manuals and user guides at all-guides.com WHILE DRIVING YOUR ZERO GRAVITY MICRO™ WALL RACER, MAKE SURE TO FOLLOW THESE RULES Stand at least 4’ from the wall. Do not drive to or off the edge of the wall. Only drive on smooth, clean, dry surfaces.
- Page 3 If the vehicle turns to the RIGHT, press the Left trim button until it drives straight (B). When finished playing with your Zero Gravity Micro™, remove vehicle from wall. Turn vehicle OFF. Turn the controller OFF. NOTE: The trim setting will reset when the vehicle and controller are turned off.
-
Page 4: Troubleshooting
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. This Class B digital apparatus complies with Canadian ICES-003. IMPORTANT BATTERY INFORMATION: Your Zero Gravity Micro™ is equipped with a Lithium Polymer battery. • Do not mix old and new batteries. WARNING: •...
Need help?
Do you have a question about the Zero Gravity Micro and is the answer not in the manual?
Questions and answers