To Modify A Conventional Light Look When You Are Running A ShowBlind Edit - Leprecon LP-X24 User Manual

Save
01 02 03 04 05 06 07 08 09 10 11 12
FF
25 50
13 14 15 16 17 18 19 20 21 22 23 24
Select
4. Press the Save softkey.
5. Repeat steps 2 through 4 for each look you want to modify.
6. When you are done, return to Run mode.
7. Optional: Return all Manual Scene Faders to the desired levels and then raise the
Manual Fader up from the zero level.
To Modify a Conventional Light Look When You are Running a
ShowBlind Edit
This operation will work on any playback except one that is in page hold mode. For
example, if you are running a scene list on Page 1, Playback 1, you will not be able to
edit a scene list on Page 2, Playback 1. This is because Playback 1 is in page hold
mode and will not switch to Page 2 until the Playback 1 level is brought to zero.
1. Start by ensuring that all buttons and faders are in the proper positions.
Button/Fader
Modes
Display
Filter
Bump
Master Fader
Manual Fader
Programmer Fader
The LP-X displays the following message:
Conventional Light Programming
Edit: PG 1 PB 6 Step: 1
Level
Setting
Edit and Scene
DIM
DIM or BOTH. Should be set to BOTH if you have an
moving light information recorded with the scene.
Any setting
Up (typically full on)
Down (typically zero)
Down
Chapter Three
Fade
0:00
LP-X24 and LP-X48 Users Manual
79