Wavetek Meterman 235 Software Manual page 3

The software support package is designed to give you full flexibility in combining
the power of your PC with the precision electronics measuring of your Model 235
DMM. The results of combining these two tools gives you the capability of
displaying, recording, saving and printing in a variety of formats any
measurement parameter being performed by the DMM. In addition, the PC
software can be set up to monitor a measurement during specific time frames,
alert you when and if a measurement goes outside specified limits and record all
the results for transmission to remote locations, archiving or analysis at a later
date.
Please note that the computer, to which the meter is attached, generates the time
and date used for the 235 multimeter monitor display and stored data. For Year
2000 compliance issues, please check with your computer manufacturer.
PC and Windows
PC:
Operating System: MS Windows versions WIN95 or WIN98
Installing Model 235 PC Software
Steps
1) Insert the 235 Software Disk 1 in drive A (B). Close all open applications on
the PC
2) For Window's 95 or 98: Press the START, then RUN buttons
3) In the command line type "A:\setup (B:\setup if disk 1 is in the B drive) &
<ENTER>
4) You will be asked a series of questions by the loader routine concerning
desired folder and icon placement. You can accept the Wavetek defaults or set
your desired path. You will also be prompted when to insert each of the
succeeding disks.
5) A message will advise when the load is complete and prompt for a restart.
Restart the computer to activate the 235 PC software package. This
application will appear on your list of programs. Continue with Getting Started
section for more assistance.
Model 235 Software Introduction
TM Minimum Operating Requirements
IBM type platform with 486 or better processor.
8MBytes of free hard disk space
RAM at least 2MB
One available serial port
- 1 -