Using The Sc-2000Usb; Installing The Ink Ribbon Cassette; Loading Draft Sheets And Installing The Draft Tray - Brother Stampcreator PRO SC2000USB Quick Reference

Hide thumbs Also See for Stampcreator PRO SC2000USB:

Operation manual (63 pages)

Table Of Contents

Table of Contents

After you have designed a stamp layout using the P-touch Editor software or Stampcreator Express software, you can

engrave it into a stamp.

Installing the ink ribbon cassette

a Press down on the ink ribbon compartment cover button to open the

cover.

☞ Open and close the ink ribbon compartment cover by pressing

only on the positions specified.

b If the ink ribbon in the cassette is loose, turn it over and use your finger

to wind the toothed wheel on the large knob on the right side until

there is no slack in the ribbon.

c Insert the knobs on the left end of the cassette into the slots on the left

side of the compartment, then push down on the right end of the

cassette so that the knobs on the right side slide into the slots on the

right side of the compartment.

d Slowly close the ink ribbon compartment cover so that it locks into

place.

☞ Be careful not to pinch your fingers with the compartment cover while closing it.

Loading draft sheets and installing the draft tray

a Slide out the inner tray.

b Lift up the draft tray lid.

c Place the draft sheets (with the words "DRAFT SHEET" facing up) into

the draft tray so that the corners of the sheets fit under the tabs in the

front corners of the tray.

☞ No more than 50 draft sheets should be loaded into the draft tray.

Be sure that there is no dust, fingerprints, etc. on the draft sheets.

Do not use a draft sheet that has been folded.

Be sure that a cleaning sheet is not accidentally inserted together

with the draft sheets.

d Close the draft tray lid.

e Slide the inner tray back into the outer case.