Playback; Normal Playback - Tascam MD-301mkII Owner's Manual

Playback

Buttons used on this page

Normal Playback

1. Press the [POWER] button.
... "NO DISC" appears on the display.
... Turn on the amplifier and set the input
selector to MD.
2. Insert an MD.
Hold the MD with the
label side up.
Insert in the direction
of the arrow.
... After the TOC (Table Of Contents) data
has been read, the disc title (when the
disc has a title assigned to it), the total
number of tracks and the total playing
time of the disc are displayed.
Total number of tracks Disc title
Music calendar
... The disc or track title can be scrolled on
the display with the [SCROLL] button on
the remote control unit. After scrolling,
the title returns to its original display.
3. Start playback.
Press the [ ¥ PLAY] button (" ¥
Playback starts from the first track and
"001" appears on the "TRACK NO."
display.
... When the disc finishes playback, the
track numbers disappear from the music
calendar.
... If the total number of tracks exceeds 20
(" " lights up), the track number
should be confirmed on the TRACK NO.
display.
... Press the [
¥ PLAY] button immediately
after recording is stopped (within 10
seconds) to play back a track which has
just been recorded from the beginning.
... If ten seconds or more have passed after
recording is stopped, or if the [
button is pressed after pressing the
ª
[ STOP] button, playback starts from
the first track of the disc.
4. To stop playback, press the [
button.
ª To stop playback temporarily (ready)
Press the [ π READY] button (" π " lights up).
... Press the [
¥ PLAY] or [ π READY] button
to resume playback.
– 9 –
ª To play a track located before or after
" lights up).
the current track
Turn the [ µ
... If you are operating the remote control
unit, select the desired track by pressing
the [ µ TRACK
the track number with the numeric
buttons.
... The selected track number starts
playing.
ª To eject the MD
Press the [ø EJECT] button.
ª Headphones
When using headphones, connect the
headphone plug into the PHONES jack.
¥
PLAY]
... Adjust the level of the signals output
from the phones jack.
ª STOP]
When the deck is moved directly from a
cold to a warm location or when the
temperature is raised suddenly in the
room where the deck is installed,
moisture may condense inside the
mechanism. This will prevent the deck
from operating normally and may result
in damage to the MD or to precision
parts. If condensation occurs, turn on
the deck and leave it for an hour or two
until the moisture evaporates.
TRACK ≤ ] dial.
≤ ] buttons or entering
Condensation