Outdoor Sensor; Initial Operation - Conrad WS 7060 Manual

Outdoor sensor

A – Sensor number (same as default channel setting)
C – Channel switch (default set to sensor number)
E – Battery compartment

Initial operation

- Slide the battery cover off the battery compartment of all sensors and the main station.
- Make sure that the set number on the channel switch is the same as sensor number on front of sensor.
- Insert 2 x AAA batteries into the battery compartment of each of the outdoor sensors.
- Insert 2 x AAA batteries into the battery compartment of the main station.
- Slide the battery cover back onto the battery compartments of all outdoor sensors and the main station.
- When fully powered, the display on the main station will show all symbols for 2 seconds and then change into
sensor receiving mode for 3 minutes. Keep the sensors close to the main station until all channels display
Manual – WS 7060
B – Wall mounting hole
D – Battery cover
F – Stand
- EN02 -