Table of Contents
Advertisement
D. SOUND MODE: BYPASS/MUSIC/MOVIE
Selects media preference.
BYPASS: Reference
MUSIC: Boosts +1.5dB @ 50Hz
MOVIE: Boosts +3dB @ 30Hz
DEFAULT: BYPASS
E. NIGHT MODE: ON/OFF
ON: Limits high and low sound threshold for night time viewing. Reduces
maximum power to 250W and relative sub level by 3dB.
OFF: No limiting
DEFAULT: OFF
F.
POWER CONTROL: FRONT PANEL/12V TRIGGER/AUDIO SENSE
Sets the power on state.
FRONT PANEL: Always on. Amplifier does not turn off automatically.
Turn until ON/OFF using the front panel power button.
12V TRIGGER: Amplifier turns on when 12V signal is detected
and off when 12V signal is absent.
AUDIO SENSE: Audio Sense enabled. Amplifier turns on when audio
signal is detected. Unit enters standby mode if no signal is detected after
15 minutes.
DEFAULT: FRONT PANEL
G. IR DEVICE ID: 1/2/3/4
Assigns an IR ID for each amplifier appearing in a system set up. Refer to
the support tab of the product page to download the Control Protocol.
DEFAULT: 1
H. LOCK CONTROLS: ON/OFF
Locks the controls to prevent accidental changes in settings. Press and
hold knob for 10 seconds to unlock.
ON: Locks controls
OFF: Allows adjustment of settings
DEFAULT: OFF
I.
FACTORY RESET
Resets all functions to default settings. Push the knob to enter the reset
menu, turn the knob once to select firmware reset, then push once more
to reset to factory settings.
NOTE: Firmware version is displayed on screen when selected.
MENU EXIT SCREEN
J.
Press the selection knob to exit to the main menu screen, or turn the
selector knob to scroll to the beginning of the sub menu. The selector
knob will advance the sub menu continuously in both directions. To exit
the sub menu, scroll either direction until reaching the "Menu Exit"
screen and press the knob.
NOTE: The volume level can be adjusted immediately once exiting the
sub menu to the main menu.
Advertisement
Table of Contents
