ABB 6128/10-500 Series Operating Instructions Manual page 40

ENG 16
Programming the time of the control process
Mark "Point in time" and change to "Point in time".
,
Set hours (08) and acknowledge.
,
Set minutes (10) and acknowledge.
,
Exit the menu. The control time 8:10 is now activated in this time block
for a switching process.
Programming the type of switching process
Mark "Value" and change to "Value".
,
Mark „Up" and acknowledge. This mark is saved and exit from the
,
menu is automatic. The "Time block 1.1" menu is displayed.
The control time is to adapt automatically to the seasonal changes in sunrise and
sunset. As the sun rises very early in summer, the blind is not to move up before
6:30. To achieve this, the blocking status "not before" and the blocking time
"06:30" are set up.
Mark "Astro function" and change to "Astro function".
,
Mark "Status" of astro function and change to "Status".
,
Mark „Active" and acknowledge. This mark is saved and exit from the
,
menu is automatic. The "Astro function" menu is displayed again.