Table of Contents
Advertisement
the heater while it is hot.
Please note:
This symbol indicates recommendations and important in-
formation for the user.
- We recommend that you not place the
heater in a draught, because strong
draughts of air may adversely affect
the equipment's operational efficien-
cy.
- Only use the heater in an upright posi-
tion.
- The heater must be positioned at least
50cm from furniture or other objects.
- The first time you use the appliance,
operate it of at least 15 minutes with
the thermostat at maximum to elim-
inate the "new" smell.
A little smoke due to the protective
substances applied to the heating el-
ement before transport may be given
off.
- Position the appliance so that the plug
and the outlet can be easily reached
even after installation.
- Do not use the appliance in rooms less
than 4 m
in area.
2
- The appliance is fitted with a safety
device which will switch off it in case
of accidental overheating.
To reset, please contact Customer Ex-
perience, see enclosed guarantee.
Use in compliance with intended use
Use this heater only as described in this manual. All other
use is considered improper. This appliance is not suitable for
commercial use. The manufacturer is not liable for damage
deriving from improper use of the appliance. This is a
household appliance only. It is not intended to be used in:
•
staff kitchen areas in shops, offices and other working
environments;
•
farm houses;
•
by clients in hotels, motels and other residential type
environments;
•
bed and breakfast type environments.
Use in this manner will invalidate the manufacturers war-
ranty.
Disposing of the appliance
The appliance must not be disposed of with house-
hold waste, but taken to an authorised waste sepa-
ration and recycling centre.
Fundamental recommendations regarding safety
Dear Customer – The plug on this appliance will get 'warm'
during use, this is perfectly normal.
This product is A HIGH POWER HEATING APPLIANCE designed
to our usual high standards but please make sure your wall
sockets are in good condition and the plug is inserted
correctly to avoid any accidental overheating.
We suggest that you check the plug AND THE SOCKET
regularly if the heater is in prolonged use, if you are in any
doubt please consult an electrician.
DESCRIPTION
A
thermostat control knob
B
switch
C
power cable
USE
General features
Remove the appliance from the packaging, turn upside
down. Check that neither the appliance nor the power cable
has been damaged in any way during transportation.
Do not operate the appliance if damaged
Electrical connection
Before plugging into the outlet, make sure the voltage of
your outlet supply corresponds to the value V indicated on
the appliance and that the socket and power line are appro-
priate for the load required.
Switching on
-
Plug into the mains socket.
-
Turn the thermostat control knob clockwise to the high-
est setting (6) and switch on.
-
Button in position «I»: ON (indicator light on).
-
Button in position «O»: OFF (indicator light off).
-
To turn appliance off, press the switch in «O» position or
remove plug from wall socket.
5
Advertisement
Table of Contents
