Environmental Notice - Braun 3 Series Manual

Beard trimmer head with 5 combs (BT32)
The beard trimmer head and the 5 combs (13) are designed for a precise and even trim.
Before trimming: Turn the appliance off. Pull off the Foil & Cutter cassette and attach
the trimmer head. It can be attached either way.
Trimming to a certain length: Attach one of the combs onto the trimmer head with
the appliance turned off. The numbers on the combs correspond to the approx.
trimming length in mm. It is advisable to begin with a higher length and step down until
you reach the desired beard length.
Trimming: Turn the shaver on. Hold the attachment with the angled edge against your
beard and guide the trimmer against the direction of the hair growth.
Cleaning with water: Switch the appliance on (cordless) and rinse the trimmer head
under hot running water until all residues have been removed. The comb attachments
can also be cleaned with water.
Cleaning with a brush: Switch off the appliance. Using the brush, clean the trimmers
and the comb attachments.
To keep the cutting system working properly, oil it with light machine oil after each use.
Accessories
Foil & Cutter cassette: 32S/32B
Styling attachment for Series 3 shavers*: BT32
* Fits all Series 3 shavers with Foil & Cutter cassette 32S/32B
(Types 5416/5415/5414/5413/5412/5411)

Environmental notice

Product contains batteries and/or recyclable electric waste.
For environment protection do not dispose of in household waste,
but for recycling take to electric waste collection points provided in your country.
Subject to change without notice.
For electric specifications, see printing on the special cord set.
23