Technical Data; Safety Instructions - Klarstein 10029859 Instruction Manual

Dear Customer,
Congratulations on purchasing this equipment. Please read this manual carefully and take care of the following
hints to avoid damages. Any failure caused by ignoring the mentioned items and cautions mentioned in the
instruction manual are not covered by our warranty and any liability.
Item number
Power supplay
General Hints
• To protect against ceramical hazards do not immerse the mains plug, power base, or kettle in water or any
other liquid.
• Do not use in the bathroom or near any source of water. Do not use outdoors.
• Do not touch hot surfaces. Use handles or knobs.
• Do not open the lid while the water is boiling.
• Take care when pouring pour slowly, and do not overfill the kettle.
• Water can remain hot for a considerable time after boiling and can present a scald hazard. Keep the kettle,
the power base, and the mains lead away from the edge of worktops and out of the reach of children.
• Do not allow the mains lead to hang over the edge ot the table or worktop, or any where it may be acciden-
tally caught or tripped over.
• Close supervision is necessary when any appliance is used near children.
• Unplug the power base from the wall socket when not in use, before repositioning and before cleaning.
Allow the kettle to cool down fully before cleaning and before storing away.
• Ensure that the lid is closed before switching the kettle on, otherwise it may not switch off.
• Check that the kettle is properly located on the power base before switching it on.
• Do not switch on unless the kettle contains at least 1 cupful of water, otherwise you may damage it.
• Remove the kettle from its power base before filling or pouring.
• Do not place the kettle, power base or mains lead on or near any hot surface, hotplate, hot hob or burner.
• Do not use the kettle for any purpose other than heating water.
• Use the kettle only with power base supplied (and vice versa)
• Do not operate any appliance with a damaged cord or plug, or after the appliance malfunctions. Or has been
damaged in an manner. If the mains lead is damaged, it must be replaced be a special lead available from
the Service department
• Ensure that the lid is closed before switch
5

Technical Data

10029859, 10029860, 10029861
220 V ~ 50 Hz

Safety Instructions