HP NetStorage 6000 Quick Start Manual page 3

Connect the Unit
B.
D.
Enter Network Information
Use a Web Browser to Enter Network Settings
All manuals and user guides at all-guides.com
A. Connect a network cable to the new port(s).
B. Reconnect the two power cords on the back panel of the
HP NetStorage unit, and plug them into your power source.
A.
C. Turn on the unit.
D. Press the alarm-reset button
the alarm. The alarm sounds whenever the unit is powered on.
A. Follow one set of the directions below:
• If your system uses DHCP, the LCD panel will display the
IP address of the first NIC port. Move to Step 8.
• If your system does not use DHCP, use the LCD panel and
arrows to configure the IP address, Subnet mask, Broadcast
address, and Gateway address (if needed) for the newly installed
NIC. Move to Step 8.
NOTE: Only one Gateway address is supported, regardless of the
number of NIC ports installed.
A. Using a computer on the network, open a web browser and enter
the unit's IP address in the browser's address or location field.
B. Select Configuration > Network Settings.
C. Type in or verify the IP address and Subnet Mask for each new NIC
you installed.
D. Click Apply.
on the front panel to turn off