Philips 32PFL3606H/12 Service Manual page 13

4
2
4
4
Figure 4-5 SSB removal [1/2]
6
6
Figure 4-6 SSB removal [2/2]
4.3.3 Power Supply Unit (PSU)
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the PSU.
1. Release the Power board cables from their clamps.
2. Unplug power connectors from the SSB, as it is not
unplug-able at the PSU itself (soldered connector).
3. Unplug all other connectors from the PSU.
4. Remove all fixation screws from the PSU.
5. The PSU can be taken out of the set now.
4.3.4 Speakers
1. Release the speaker cables from their clamps.
2. Unplug the speaker connector from the SSB.
3. Take the speakers out.
When defective, replace the both units.
4
1
4
3
19080_103_110302.eps
19080_104_110308.eps
Mechanical Instructions
4.3.5 Stand removal
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Be sure to put the set in
the Service Position.
1. Remove the fixation screws.
2. Take the stand out.
4.3.6 IR/LED Board
Refer to Figure 4-7
1. Remove the speakers as described earlier.
2. Remove the stand as described earlier.
3. Release the clamps that hold the boards cable.
4. Remove the fixation screws [1], [2] that secure the LCD
panel with the bezel.
5. Lift the LCD Panel from the bezel.
6. Gently release the clips that hold the board and take it out
from the bezel.
7. Unplug both the connectors from the IR/LED board.
When defective, replace the whole unit.
110404
2
2
2
5
4.3.7 Keyboard Control unit
1. Remove the speakers as described earlier.
2. Remove the stand as described earlier.
3. Release the clamps that hold board cable.
4. Remove the fixation screws [1], [2] that secure the LCD
panel with the bezel. Refer to
110404
5. Lift the LCD Panel from the bezel.
6. Gently release the clips that hold the board and take it out
from the bezel.
7. Unplug the connector from the keyboard control panel.
When defective, replace the whole unit.
4.3.8 LCD Panel
1. Remove the SSB as described earlier.
2. Remove the PSU as described earlier.
3. Remove the speakers as described earlier.
4. Remove the stand as described earlier.
5. Release the IR/LED board cable from its clamps and
unplug the IR/LED board cable.
6. Remove the fixation screws [1], [2] that secure the LCD
panel with the bezel. Refer to
7. Lift the LCD Panel from the bezel.
8. Remove the fixation screws that secure the panel with the
metal subframe.
9. Release the clips from both the LVDS Flat Foil connectors
that connect with the LCD panel.
Caution: be careful, as these are very fragile connectors!
Take the flat foils out of their connectors.
When defective, replace the whole unit.
back to
div. table
TPM6.1E LA 4.
for details.
2
2
1
1
Figure 4-7 IR/LED removal
Figure 4-7
Figure 4-7
EN 13
2
2
2
19080_105_110308.eps
110308
for details.
for details.
2011-Jun-10