Name Of Parts; Indoor Unit; Remote Controller - Fujitsu AOYG12KETA Operating Manual

Battery loading and remote controller preparation
(R03/LR03/AAA x 2)
2
3
1
~ Put batteries as shown in the fi gure above.
1 3
4 Press to start clock setting.
Press
5
(
to Sunday).
* By pressing
changed from a 24-hour to a 12-hour clock.
Press to continue.
6
Press
7
(
Press the buttons to change the clock by a minute.
Press down the buttons to change the clock by 10 minutes.
8 Press to complete the setting.
Be close to the indoor unit. If you press the button from a
distance, settings may not be properly sent.
NOTES:
• Use specifi ed type of batteries only.
• Do not mix different types or new and used batteries together.
• Batteries can be used about 1 year in ordinary use.
• If the remote control range noticeably shortens, replace the
batteries, and press

3. NAME OF PARTS

For appropriate signal transmission between the remote
controller and the indoor unit, keep the signal receiver
away from the following items:
- Direct sunlight or other strong lights
- Flat-panel television screen
In rooms with instantaneous fl uorescent lights, such as
inverter type ones, the signal may not be transmitted
properly. In such a case, consult the store of purchase.

3.1. Indoor unit

Air fi lter
*1)
Intake grille
Air cleaning fi lter
Horizontal airfl ow
Indicator lamps
direction louvers
*1) Before starting operation, make sure that the intake grille is closed
completely. Incomplete closing may affect the proper function or
performance of the product.
*2) Indicator lamps light in the following conditions. It cannot see when
the indicator lamp is off.
En-3
8
4
to set day of the week (Monday
)
, the time indicator can be
to set the clock.
)
as shown in page 4.
CAUTION
For Manual Auto operation
and Filter indicator reset
(Refer to page 13.)
Front panel
Rating label
Drain hose

Remote controller

*2)
signal receiver
Name
Operation Green
6
Timer Orange
5
7
Economy Green
W-LAN Orange
(optional)
3.2. Remote controller
When you use the optional remote controller, the appearance
and the operation procedure may differ.
For details, please refer to the operating manual of each remote
controller.
: The setting must be done while the setting screen is displayed
for each function.
: The button is controllable only when the air conditioner is
operating.
: The instruction is relating to the W-LAN control (optional).
Aim at the signal receiver of the indoor unit properly.
• Operating range is approximately 7 m.
• [ ] will appear when the signal is transmitted.
• The indoor unit will emit a beep when it receive the signal
properly. If there is no beep, press the button again.
Remote controller display
In this section, all the possible indicators are displayed for description.
In actual operation, the display is linked with the button operation, and
only shows the necessary indicators for each setting.
For Basic operations ..................... Refer to page 5.
Starts or stops the air conditioner operation.
Changes the operation mode.
Adjusts the setting temperature.
For 10 °C Heat operation .............. Refer to page 7.
Activates the 10 °C Heat operation.
For Energy saving operation ........ Refer to page 7.
Activates or deactivates the Economy
operation.
For Outdoor Unit Low Noise operation
Activates or deactivates the Outdoor Unit Low
Noise operation.
Do not press this button in normal use.
It starts the test run (for use by authorized service personnel only).
NOTES: If the test run starts unintentionally, press
run.
Color Operation or condition
Normal operation
Timer operation
Economy operation
10 °C Heat operation
W-LAN control is active.
Signal transmitter
... Refer to page 7.
to quit the test