Software Installation; Tango Driver Installation; Tango-Utilities Installation - SINUS Tango User Manual

Battery symbol
The symbol on the display shows the battery status. The following three stauses may be displayed:
The battery is fully charged. A legally binding measurement may be performed.
The battery is charged half. A legally binding measurement may be performed.
The battery is discharged. A legally binding measurement may not be performed. The device will
automatically turn off if the batteries are not replaced.

1.4 Software installation

First Tango driver must be installed for that Tango is recognized via USB connection. Second Tango-Utilities
should be installed for configuration of Tango settings and export of data.

1.4.1 Tango driver installation

Please follow the instructions below to install the SINUS driver on a PC. You find the file on the enclosed CD
or on the installation CD of the application software. Use the Windows Explorer to start the driver installation
programme. Perform the install setting and confirm always. Depending on the system performance this
procedure may take a few minutes.

1.4.2 Tango-Utilities installation

Installing the software Tango-Utilities resembles the installation procedure of most Windows applications.
Follow the instructions below:
Run the installation program (
The first window shows the software version. Click on
Set the installation directory in the next window. Click on
In this dialog you may specify the directory in the Windows Start Menu. Click on
the next dialog.
This dialog summarizes your settings. Click on
dialog.
Manual Tango
1 GENERAL INFORMATION AND DESIGN
Tango_Utilities_
10 of 34
Version .exe ).
to continue to the next window.
Next
to continue to the next dialog.
Next
to confirm these and to continue to the next
Install
to continue to
Next
SINUS Messtechnik GmbH