Tools Required For Adjustments - JVC GR-SXM335U Service Manual

1.2 TOOLS REQUIRED FOR ADJUSTMENTS

Alignment tape
1 (for SP interchangeability)
MHP-C
Torque driver
3
YTU94088
INF adjustment lens
5
YTU92001B
Gray Scale Chart
7
YTU94133A
INF lens holder
9
YTU94087
Camera stand
11
YTU93079
Jig connector cable
13
YTU93106A
1-2
Alignment tape
2
(for N. SP PB Y/C level)
MHV-2C
Bit
4
YTU94088-003
Conn. ring
6
YTU92001-111
Color Bar Chart
8
YTU94133C
Light box Assembly
10
YTU93096A
Extension connector
12
YTU94145B-30
Service support system software
14
YTU94057-51
PC cable
15
QAM0099-002
Table 1-2-1
1,2. Alignment tape
To be used for check and adjustment of interchangeability
of the mechanism.
(Video: Color bar signal, Audio: Non-signal)
3. Torque driver
Be sure to use to fastening the mechanism and exterior
parts because those parts must strictly be controlled for
tightening torque.
4. Bit
This bit is slightly longer than those set in conventional
torque drivers.
5. INF adjustment lens
To be used for adjustment of the camera system.
6. Conn. ring
The connector ring to attach the INF. lens to the head of
the OP lens.
7. Gray scale chart
To be used for adjustment of the camera system.
8. Color bar chart
To be used for adjustment of the camera system.
9. INF lens holder
To be used together with the camera stand (11) for
operating the VideoMovie in the stripped-down condition
such as the status without the exterior parts or for using
commodities that are not yet conformable to the
interchangeable ring.
10. Light box assembly
To be used for adjustment of the camera system.
11. Camera stand
To be used together with the INF adjustment lens holder.
12. Extention connector
To be used to JIG connector cable
13. JIG connector cable
Connected to CN25 of the main board and used for
measuring error rates, etc.
14. Service support system software
To be used for adjustment with a personal computer.
15. PC cable
To be used to connect the VideoMovie and a personal
computer with each other when a personal computer is
used for adjustment.
16. Cleaning cloth
Recommended cleaning cloth to wipe down the video
heads, mechanism (tape transport system), optical lens
surface.
Cleaning cloth
16
KSMM-01