Kaba Mauer 70094 Convar F Operating Instructions

Operating Instructions 70094 Convar F / 70096 Convar B
1 Important Instructions
The locking mechanism works smoothly. No force should be applied. This should be particularly avoided when inserting the
•
key in the lock.
The locking mechanism can only be changed over to another pair of keys if one valid key is still available. The lock should
•
be converted to a new pair of keys immediately if a key is lost.
Opening the lock with a damaged key can result in damage to the lock.
•
The function of the lock could not be secured, if you use damaged or heavily worn out keys. We recommend to check the
•
condition of the keys before using them and to not use or, if necessary, to change the keys, if they are damaged or heavily
worn out.
The lock must not be lubricated.
•
The lock may only be installed by specialist personnel and only opened by the manufacturers. Unauthorised opening will
•
lead to invalidation of any guarantee claims.
Only original Kaba Mauer keys are to be used should additional keys be required, as otherwise no guarantee claims may
•
be raised.
2 Opening
Insert the key in the keyhole (long bit left). Then turn the key clockwise until stop position (approx. 140° ) is reached (see
•
diagram 1). The lock is open. The key cannot be removed in this position.
3 Locking
Turn the key anti-clockwise until stop position (approx. 0° ) is reached. The lock is locked.
•
4 Changing over
NB: The lock should only be changed over with the safe opened.
•
Insert the key in the keyhole (long bit left). Then turn the key clockwise until stop position (approx. 140° but at least 90° ) is
•
reached (see diagram 1 or 2).
Diagram 1: Key position approx. 140°
Insert the change activator in the guide at the back of the lock (see diagram 3) and turn the activator anti-clockwise until
•
stop position is reached (see diagram 4).
Diagram 3: Guide change activator
!
Diagram 2: Key position approx. 90°
Diagram 4: Turn change activator
Page 1
Revision level 06.06.2008