Hide thumbs Also See for VacuFormer:

Advertisement

Cavex VacuFormer
VacuFormer_Handl_GB.indd 1
29-07-09 11:23

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the VacuFormer and is the answer not in the manual?

Questions and answers

Summary of Contents for Cavex VacuFormer

  • Page 1 Cavex VacuFormer VacuFormer_Handl_GB.indd 1 29-07-09 11:23...
  • Page 2: Table Of Contents

    Instructions for use ..........5, 6, 7 Frequently asked questions / problems ......8 Maintenance and troubleshooting ........9 Technical information Contents of box: • 1 Cavex VacuFormer • 1 Guarantee certificate • 1 Connection lead • 1 Manual Technical specifications...
  • Page 3: Introduction

    NOTE! Do not place the Cavex VacuFormer too close to walls, cupboards, other equipment, etc. Place the CVF on a stable surface with sufficient space around it.
  • Page 4: Parts

    7. Height handle (*) Heating starts when the switch is set to “Heating” (–); the red light comes on. The vacuum motor starts when the switch is set to “Vacuum” (=); the green light comes on. VacuFormer VacuFormer_Handl_GB.indd 4 29-07-09 11:23...
  • Page 5: Instructions For Use

    1 mm. Fig. 1 2. Place the required deep-draw sheet in the frame (fig. 2) and close it carefully. Slide the frame all the way up (fig. 3). Fig. 2 Fig. 3 VacuFormer VacuFormer_Handl_GB.indd 5 29-07-09 11:23...
  • Page 6 Fig. 4 4. Swivel the heating element over the frame with the deep-draw sheet (fig. 5). Preheat the sheet until it hangs down by 2 to 3 centimetres (fig. 6) Fig. 6 Fig. 5 VacuFormer VacuFormer_Handl_GB.indd 6 29-07-09 11:23...
  • Page 7: Instructions For Use 5

    !! The CVF has overheating protection. The mechanism is automatically activated when the CVF is used for too long. !! Let the Cavex VacuFormer cool for at least 10 minutes after use. This prevents overheating. !! Do not leave the heating element over the handles for too long.
  • Page 8: Frequently Asked Questions / Problems

    The sheet gets stuck in the vacuum holes: Overheating makes the sheet so soft that it is sucked into the vacuum holes during the vacuum process. Prevent overheating. Carefully try to extract the sheet from the holes. VacuFormer VacuFormer_Handl_GB.indd 8 29-07-09 11:23...
  • Page 9: Maintenance And Troubleshooting

    Cavex Holland BV • PO Box 852 • 2003 RW, Haarlem T +31 (0)23 530 7700 • F +31 (0)23 535 6482 • dental@cavex.nl • www.cavex.nl VFIFU.01 VacuFormer VacuFormer_Handl_GB.indd 9 29-07-09 11:23...

Table of Contents