Unit Power-Up; Setup And Configuration - 3D Instruments Accu-Cal Platinum Instruction Booklet

PRODUCT INTRODUCTION
Turns Power on/off
Enters set-up and
configuration menus
Zeros the display,
Scrolls forward
through menu
displays
Recalls Max/Min
readings. Scrolls
backwards through
menu displays
OPERATING INSTRUCTIONS

UNIT POWER-UP

The standard Accu-Cal Platinum is sup-
plied with 3 AA batteries installed. If you
purchased the optional 24Volt powered
version, batteries are not installed.
Connect a 24V power supply to the termi-
nal block on the rear of the gauge noting
proper polarity - refer to page 6 for detailed
instructions and warnings..
Push and hold down the POWER key for 2
- 3 seconds to turn the unit on. The LCD
will briefly display the firmware version,
test the bar graph display segments and
then cycle to the "normal operation"
screen. The gauge is now ready for serv-
ice. To turn off the gauge, press the
POWER key.
Note: The gauge will read to 120% of full
scale. After that point, the gauge will dis-
play: OL (over limit). The gauge is only
calibrated to 100% of full scale.
ACCU-CAL PLATINUM DISPLAYS AND CONTROLS
(Pictured with an optional boot)
SET-UP AND CONFIGURATION
Push the CONFIG key to access the user-
settable functions on the gauge. Each time
the CONFIG key is pressed, the display
advances to the next function. Once a
function has been set, press ENTER to
exit the configuration menu, or CONFIG to
continue with further configuration. In
sequential order, the configuration menu
and operation is as follows:
1. Set Engineering Units (Default = PSI)
The unit is shipped configured to dis-
play PSI. By pressing the ▲ and ▼
(ZERO and MAX/MIN) keys you can
scroll forward and backwards through
the available engineering units including
a custom unit. When the desired unit is
displayed, press ENTER or CONFIG.
Pressure will now be displayed in the
chosen engineering units. Refer to
pages 16 and 17 of this manual for a
list of available engineering units. See
the Supervisory Mode section for details
on setting up custom units.
Pressure display
Engineering Units
0 - 100% bar graph
Selects an action in
configuration.
Also turns the back-light
on/off
KT-099
Page 3 of 20
06/07