Throttle Wire/Stop Cord; Installation Of Blade Guard - Tanaka TBC-250 Owner's Manual

TBC-270PN/PND,TBC-300/SDH/3010,TBC-340/D,TBC-340PF/D
www.tanaka-usa.com
TBC-250/250PF/PFD,TBC-2501,TBC-2510,TBC-270PF/PFD

Throttle wire/stop cord

Remove the air cleaner cover. (Fig. 1-4)
Connect stop cords. (Fig. 1 -5)
Connect throttle wire end to carburetor. (Fig. 1 -6)
Cover throttle wire and stop cords together with protective tube
provided up to air cleaner cover. (Fig. 1 -7)
Installation of blade guard (Fig. 1-8, 8B)
Install the blade guard on the drive shaft tube against the
gear case.
Tighten the guard bracket firmly so that the blade guard does
not swing or move down during operation.
When using a trimmer head (2), locate the guard above
the gear case. (Fig. 1-8C, 8D,8E)
CAUTION!
Some blade guards are equipped with sharp line limiters. Be
careful when handling it.
6
Owner's Manual
custsvc@tanaka-ism.com