tryten Nova Pro Assembly Instructions

Nova Pro/Go Mobile Tablet Station
ASSEMBLY KIT
Nova Hardware Packs
Nova Hardware Pack
• Felt Pads 3/4" x 1/8" thick (6)
• Label Hardware Kit Nova (1)
• Hex L-Key, 3/16" size, 3" length (1)
• Torx Security L Key, T25, 2-11/16" long (1)
• Hex L-Key, 5/32" size, 2-11/16" length (1)
• Keys Set Tablet Cart Nova (1)
• Screw 10-24 by 3/4" Security Torx, Button head, SS (1)
• Screw 1/4-20 by 1" Socket Head, Zinc (4)
• Belleville Washer 1/4" 18-8 SS (4)
ASSEMBLY INSTRUCTIONS

1. OPEN THE SHIPPING BOX

•
Open shipping box and remove base assembly.
BASE ASSEMBLY
•
Extract hardware pack.
HARDWARE PACK
•
Remove Pole assembly from packaging.
POLE ASSEMBLY
For additional questions or technical support, please contact Tryten at tryten.com/contacts or
1(800) 860-4455

2. ASSEMBLE THE POLE ASSEMBLY

• Assemble the Pole assembly to the base with the 4 screws and dome washers using the 3/16-
inch hex L key from the hardware pack.

3A. ADJUST OMNITAB UNIVERSAL BRACKET TO FIT TABLET

The Universal bracket comes adjusted to fit the standard iPad 9.7.
•
Unlock the top slider using the set of keys from the hardware pack.
•
Remove the top slider from the OmniTab.
•
Loosen the 3 screws using the 1/8-inch hex L key from the hardware pack.
ADJUSTMENT SCREWS
•
Pull sliders to the appropriate size tablet.
• Tighten the three adjustment screws.
• Slide the tablet into place.
• Insert the Top slider and push the locking button.
LOCK BUTTON

3B. WHEN A TABLET HAS A CASE, INSTALL 2ND SET OF SLIDERS

a) Remove 4 felt pads from Universal bracket.
FELT PADS
b) Remove 4 screws holding the cover of the Universal bracket using the 1/8-inch hex L key from
the hardware pack.
COVER
HOLDING SCREWS
Remove cover and the 3 screws
c)
holding the sliders using the 1/8-inch
hex L key from the hardware pack.
d) Remove for sliders and replace with the set of sliders from hardware pack.
e) Install the 3 screws holding the sliders using the 1/8-inch hex L key from the hardware pack.
SLIDERS
HOLDING SCREWS
f) Put back the cover and install the 4 screws removed at step b) using the 1/8-inch hex L key from
the hardware pack.
COVER
HOLDING SCREWS
g) Apply the set of felt pads supplied
in the hardware pack on top of the
screws.
Adjust sliders and install tablet
h)
following the instructions from
Step 4.