HUALIAN FS-600H Operating Instructions

TROUBLESHOOTING

MALFUNCTIONS REASONS
No sealing Disconnected plug
Power lamp is off Power cord is broken
Transformer is broken
No sealing Heater (heating element) is
broken
Power lamp is on
Spring hook our mounting
Sealing lamp is on
spring is loose or in poor
contact
Terminals of the heating Terminals of the heating
element are in poor
contact
No sealing Microswitch is activated
Power lamp is on Defective microswitch
Sealing lamp is off
Teflon cloth burn Timer malfunction
Prolonged heating time
Heating wire breaks Worn Teflon adhesive
Seal is wrinkled Heating timer is set too
high
Cooling time is not enough Cooling time is not enough
Imperfect seal Worn Teflon cloth
Worn silicone rubber
Broken seal Prolonged sealing time
Non-full-weld seal Sealing time is too short
Seal sticking Dirty Teflon cloth
Dirty sealing bar
SUGGESTIONS
Check or change the plug
Replace or repair the cord
Replace the transformer
Replace the heater
Clean or tighten spring
hook connection
Clean the terminals and
adjust if needed
Adjust the microswitch
lever
Adjust the microswitch
position
Replace the microswitch
Replace timer or relay
Decrease the timer
setting
Replace the Teflon
adhesive
Lower the timer setting
Continue pressing the
upper lever for 1-2 upper lever for 1-2
seconds after the light
goes off
Replace Teflon cloth
Replace silicone rubber
Decrease timer setting
Increase sealing time
Clean the Teflon cover
Clean the silicone rubber
sealing bar
LONG HAND
IMPULSE SEALER

OPERATING INSTRUCTIONS

FS-600H, FS-800H, FS-100H
MODELS