Advertisement
3.
PreParinG WrencH for use
WarninG! Ensure the air supply is clean and does not exceed 90psi while operating the
wrench. Too high an air pressure and/or unclean air will shorten the product life due to
excessive wear, and may be dangerous, causing damage and/or personal injury.
3.1.
air suPPLy
recommended hook-up procedure is shown in Fig.1.
3.1.1. Ensure wrench air valve (or trigger) is in the "off" position before connecting to the air supply.
3.1.2. You will require an air pressure of 90psi, and an air flow according to specification.
3.1.3. Drain the compressor air tank daily. Water in the air line will damage the wrench.
3.1.4. Clean compressor air inlet filter weekly.
3.1.5. Line pressure should be increased to compensate for unusually long air hoses (over 8
metres). The minimum hose diameter should be 1/4" i.D. and fittings must have the same
inside dimensions.
3.1.6. Keep hose away from heat, oil and sharp edges. Check hose for wear, and make certain
that all connections are secure.
3.2.
couPLinGs
Vibration may cause failure if a quick change coupling is connected directly to the wrench.
To overcome this, connect a leader hose to the wrench. A quick change coupling may then
be used to connect the leader hose to the air line recoil hose (See Figs.1 and 2).
3.3.
HanDLe
Mount the handle to the top of the impact wrench using the two allen bolts provided.
fig.1
fig.2
SA6005
Original Language Version
SA6005 issue: 3 - 15/12/11
Advertisement
