Chiller Use; Setting The Control; Draining The Chiller; Reconnecting The Chiller - Oasis R1P Installation Instructions And Use And Care Manual

Your chiller has a dial for water temperature control.
For colder water: Turn it clockwise (to the right).
For less cold water: Turn it counterclockwise (to the left).
To shut down the chiller: Turn the dial to the Off position at full counterclockwise (extreme left).
Allow one hour to obtain chilled water.

Draining the Chiller

1. Unplug the chiller.
2. Shut off water supply to chiller.
3. Open faucet to release pressure.
4. Disconnect the water lines attached to the chiller by
depressing collet on easy to connect fittings.
5. Tip chiller to the left side (power cord side) and drain water
into a large container.
6. Set chiller in its normal upright position for storage.
If the chiller does not operate,
check for these conditions first:
Has the circuit breaker tripped or has a house fuse blown?
Is the power supply cord plugged into a grounded
3 prong outlet?
Is the electrical outlet controlled by a switch?
6

Chiller Use

Setting the Control

Before calling for service...

Reconnecting the Chiller

1. Shut off water supply to chiller.
2. Put chiller in position, allowing a 2" (5 cm)
space around the side and top.
3. Connect water lines as described in the ''Install the
Chiller'' section.
4. Slo wly open main water supply valve and open faucet
until water flo ws.
5. Plug in chiller and set dial to desired water temperature.
(See the "Setting the Control" section).
Is the Temperature Control set to the "Off" position?
Has the water supply been turned off?