B) Cleaning; Handling - Renkforce DB-L6F Operating Instructions Manual

b) Cleaning

Disconnect the device from the power supply and leave it to cool down before cleaning.
The device is maintenance-free and you should therefore never open it. If you open it, the guarantee will
expire.
Only clean it with a soft, dry cloth or a brush only. Never use aggressive cleaning agents or chemical solu-
tions as the surface of the casing could be damaged.
The fog machine can be cleaned with a moist cloth on the outside. Never use aggressive cleaning agents,
chemical solutions or scouring agents as the paint coating could be damaged.
Avoid deposits and residue in the fog fluid channels by using a special fog machine cleaner. Observe the
instructions for cleaning liquid.

12. Handling

• Never connect the mains plug to a mains socket immediately after the device has been taken from a cold
to a warm environment. The resulting condensation may destroy the device.
Allow the device to reach room temperature before connecting it. Wait until the condensation has eva-
porated.
• Never pull the mains plug from the mains socket by the cable. Only pull it from the mains socket by the
intended grip areas.
• Unplug the mains adapter from the mains socket after use.
• Disconnect the mains plug from the mains socket during thunderstorms for reasons of safety.
• Never touch the device in operation or right afterwards, because this area heats up strongly particularly
in the area of the fog exit opening. There is a danger of burns.
• Never use contaminated fog liquids. Close the tank and the storage container for your fog liquid immedi-
ately after filling.
• Always empty the tank before transporting the device or if you are not using it for a longer period.
• Use only water-based fog liquid. Suitable fog liquids are listed in the „Technical Data" section.
36