Configuring The Untrust Interface; Changing Your Admin Name And Password - Juniper NETSCREEN-5GT User Manual

– Data Bits: 8
– Stop Bit: 1
– Flow Control: None
4. Enter netscreen in both the login and password prompts. (Use lowercase
letters only. The login and password fields are both case sensitive.)
C
ONFIGURING THE
Your network uses the Untrust interface on the NetScreen-5GT to connect to the Internet.
If you are setting up your Internet connection for the first time, contact your ISP for
information on your network IP address assignment.
Note: If you access the device for the first time using the NetScreen ScreenOS WebUI
graphical interface, the Initial Configuration Wizard appears when you log in to the
WebUI to guide you through the configuration described in this chapter. Therefore, only
the CLI commands are shown in this chapter.
• If your ISP gave you a specific, fixed IP address and netmask for your network,
configure the IP address and netmask for the network and the IP address of the
router port connected to the NetScreen device. Enter the following CLI
commands in a Telnet or Console session:
set interface untrust ip ip_addr/mask
set interface untrust gateway ip_addr
save
• If your network receives an IP address from a server via DHCP, enter the
following CLI commands in a Telnet or Console session:
set interface untrust dhcp client enable
save
• If your network receives an IP address from a server via PPPoE, configure the
user name and password assigned by your ISP. Enter the following CLI
commands in a Telnet or Console session:
set pppoe interface untrust
set pppoe username name_str password pswd_str
save
C Y
HANGING OUR
Because all Juniper Networks NetScreen products use the same default admin name and
password (netscreen), it is highly advisable to change your admin name and password
immediately. In a Telnet or Console session, enter the following CLI commands:
set admin name name_str
set admin password pswd_str
save
NetScreen-5GT
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
U I
NTRUST NTERFACE
A N
DMIN AME AND

Configuring the Untrust Interface

P
ASSWORD
9