Chapter 3 Configuring The Device - Juniper NETSCREEN-5XT User Manual

Table of Contents

Advertisement

Chapter 3
Configuring the Device
This chapter describes how to configure a NetScreen-5XT after you have installed it on a
desktop, connected it to a power source, and plugged in the necessary cables. Topics
explained in this chapter include:
"Operational Modes" on page 10
"Asset Recovery" on page 14
Note:
You must register your product at
ScreenOS services, such as the Deep Inspection Signature Service, can be activated on the
device. After registering your product, use the WebUI or CLI to obtain the subscription for
the service. For more information about registering your product and obtaining
subscriptions for specific services, see the "System Parameters" chapter in Volume 2 of the
NetScreen Concepts & Examples ScreenOS Reference Guide.
Note:
If you access the NetScreen-5XT for the first time using the NetScreen ScreenOS
WebUI graphical interface, the Initial Configuration Wizard appears when you log in to
the WebUI. This Wizard guides you through the configuration described in this chapter.
For more information about starting the Initial Configuration Wizard, refer to the Juniper
Networks NetScreen-5XT Getting Started Guide.
NetScreen-5XT
www.juniper.net/support/
3
so that certain NetScreen
9

Advertisement

Table of Contents
loading

Table of Contents