Gliderol Glidermatic GTS Optima Settings Manual

Gliderol Glidermatic GTS Optima Settings Manual

Handset key settings

Advertisement

Glidermatic GTS Optima
Handset Key Settings
The following instructions demonstrate how to program or change the key settings on your Gliderol
handset, allowing you to select the specific button that operates your door. This procedure will assist
in reprogramming your handset from three-button Open/Stop/Close operation to single-button
operation. It will also assist in reprogramming your handset to operate multiple doors.
Step 1:
COVER
TAB
Carefully remove the light cover by pulling down
on the tab near the front of the unit.

Step 3: Single Button Operation (1-3 doors)

BUTTON 1
BUTTON 2
BUTTON 3
Relocate the jumper to the first two pins (on the left hand side) adjacent to the desired key label as per
the above diagrams. The jumper is the small, black sleeve that slides over the key shunts.
Note: Changing the key setting on your operator will update all programmed handsets.
Step 2:
Locate the three key shunts on the main control
board. These are labelled KEY-1, KEY-2 & KEY-3
and correspond to the buttons on your remote.
Button 1
KEY-3
KEY-2
KEY-1
Note: To operate multiple doors (up to 3) from one remote, simply place a
second jumper adjacent to the desired key label
Button 2
KEY-3
KEY-2
KEY-1
www.gliderol.com.au
KEY
SHUNTS
Button 3
KEY-3
KEY-2
KEY-1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Glidermatic GTS Optima and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Gliderol Glidermatic GTS Optima

  • Page 1 Glidermatic GTS Optima Handset Key Settings The following instructions demonstrate how to program or change the key settings on your Gliderol handset, allowing you to select the specific button that operates your door. This procedure will assist in reprogramming your handset from three-button Open/Stop/Close operation to single-button operation.
  • Page 2 Please note, this procedure will simply program the key settings on your Gliderol handset, allowing you to select the specific button that operates your Gliderol Sectional door. To program a new or additional handset please refer to our ‘Glidermatic GTS Optima Programming Additional Handsets’ factsheet.

Table of Contents