Advertisement
18. Use proper size and type air pressure line and fittings. The
recommended air line for this tool is 3/8" delivering no more than 174 PSI.
Recommended air inlet size is 1/4" - 18 nps. Recommended operating
pressure is 58 PSI.
19. Maintenance. For your safety, service and maintenance should be
performed regularly by a qualified technician.
20. You should maintain a proper regulator and moisture trap in your air
line at all times.
21. Compressed air only. Only use clean, dry and regulated compressed air at
no more than 174 PSI to power this tool. Never use oxygen, carbon dioxide
or any other bottled gas as a power source for this tool.
Warning: The warnings, cautions, and instructions discussed in this instruc-
tion manual cannot cover all possible conditions and situations that may oc-
cur. It must be understood by the operator that common sense and caution are
factors which cannot be built into this product, but must be supplied by the
operator.
When unpacking, check to make sure that the item is intact and undamaged. If
any parts are missing or broken, please call Harbor Freight Tools at the number
on the cover of this manual.
Below is a diagram of the Air Line Components normally recommended for air
tools. However, with this Paint Dryer Gun, we recommend you DO NOT USE an
in-line oiler.
Paint Dryer
Gun
SKU 95314
For technical questions, please call 1-800-444-3353.
Unpacking
Air System Set up
Page 4
Advertisement
